z/VM: CP Commands and Utilities Reference - z/VM - IBM

CPXUNLOAD
Responses
Messages
them. CP assigns and displays this load ID in the response to your CPXLOAD
command. If you cannot remember the load ID, use the QUERY CPXLOAD ALL
command (page 751).
5. For more information about unloading customer-written CP routines from CP’s
system execution space, see the z/VM: CP Exit Customization book.
Response 1:
HCP002E Invalid operand - operand
To unload the customer-written CP routines that was assigned ID 92, enter the
following:
cpxunload id 92
HCP2770I CPXUNLOAD for load ID 92 has been scheduled
Ready;
.
HCP2771I CPXUNLOAD for load ID 92 has been completed
Note that the Ready message in this response appears between the 2 messages.
The virtual machine issuing this CPXUNLOAD command did not specify anything
after the load ID, so this became an asynchronous command, by default. This
means the virtual machine is free to issue other commands before CP unloads all
the customer-written CP routines. When you specify SYNCHRONOUS, your virtual
machine cannot perform other tasks until CP unloads all of the customer-written CP
routines.
HCP003E Invalid option - command contains
extra option(s) starting with option
HCP2769E CPXUNLOAD for load ID loadid has
been rejected; the
v requested load ID was not found
v requested load ID was loaded as
PERMANENT
v requested load ID is still in use by a
system service
v request was denied by the control
entry point
HCP6704E Missing token at end of line
HCP6706E Invalid string - string
108 z/VM: CP Commands and Utilities Reference