z/VM: CP Commands and Utilities Reference - z/VM - IBM

SET DEVICES
Responses
Messages
dynamic I/O changes on the processor, CP will not let you make
dynamic I/O changes on any individual device or devices.
NOTDYNamic_i/o
tells CP not to allow dynamic I/O changes on the specified device or devices.
SENSed
tells CP to use the information returned from a sense ID request to determine
the device class or type.
NOTSENSed
tells CP not to use the information returned from a sense ID request to
determine the device class or type.
THROTtled
tells CP to limit (throttle) the rate of I/O coming from the specified device or
devices.
NOTTHROTtled
tells CP not to limit (throttle) the I/O rate of the specified device or devices.
Response 1:
To have CP accept a device, enter the following:
set devices accept 701
The Devices bit map was updated successfully
Ready;
Response 2:
HCP002E Invalid operand - operand
To have CP not permit throttling for a range of devices, enter the following:
set devices notthrottled 700-710
The Devices bit map was updated successfully
Ready;
HCP643E Command not enabled in system
configuration file
1242 z/VM: CP Commands and Utilities Reference