z/VM: CP Commands and Utilities Reference - z/VM - IBM

QUERY UR
v Select files requesting the STANDARD form
v Automatically schedule forms output
v Generate a separator page for output files
v Accept spool files that contain 3800 load CCWs
v Process spool files regardless of their length.
The third line tells you that the printer will:
v Use the forms overlay negative called 0987
v Use the system image library file IMAG3800
v Use the character set GF10
v Print six lines per inch
v Put spool files causing 3800 load checks into system HOLD status.
v Print separator pages with 60 lines per page.
The fourth line tells you that the printer will not use destination values as a criterion
for selecting files.
The fifth line tells you that the printer will:
v Process files with advanced function printer (AFP) characteristics, that is, files
that contain X'5A' CCWs or an extended attributes buffer (XAB).
v Mark separator trailer pages with separator bars.
The last line tells you the following:
v The printer is active with the spool file 0002, owned by the user DAVID.
v The number of records remaining for output in the file is 130K, where K is the
number of records in thousands rounded to the nearest 1000. If the number is
greater than 999499, the number is shown as nnnM, where M represents the
number of lines in millions rounded to the nearest million.
v There are five copies remaining for output.
v The sequence for the file on the printer is 001.
The parts of the first line of the response for impact printers and 3800 printers may
also be as follows:
Category Possible Values Meaning
Status STARTED Device is available for spooling activity.
DRAINING Device is processing a file, but will be drained after
the file is finished.
DRAINED Device is not available for spooling activity. Issue
the CP START command to activate the device.
INT REQ Device is not available, and needs manual
intervention before it can continue to process spool
files.
SETUP REQ Printer is ready to print an alignment page so that
the operator can align the forms properly on an
impact printer. The operator must press the STOP
and START buttons to print another alignment
page, or enter the START command to begin
printing the entire file.
MOUNT REQ Printer is waiting for the operator to mount a new
form.
User ID SYSTEM Device processes files for any user ID.
userid Device processes files only for the specified user
ID.
Chapter 2. CP Commands 1067