z/VM: CP Commands and Utilities Reference - z/VM - IBM

QUERY TRSAVE
The following message is displayed when a class G user issues QUERY TRSAVE
ALL but no trace IDs have been defined for which the user is authorized to view
information.
No traceids defined for your virtual machine.
Response 6:
If CP system trace data is being written to tape, the following message is displayed:
TRSAVE for CP on drive rdev1 [rdev2] MODE nnnn
{rewind} [DEFERIO FRAMES mmmmm FILLED nnnnn]
{run }
rdev1 [rdev2]
identifies the real device number or numbers of the tape drives being used for
the TRSAVE function. If only one tape drive is being used, rdev2 is not shown.
MODE nnnn
identifies the tape’s format density.
REWIND
RUN
indicates that the tape is to be rewound (REWIND) or rewound and unloaded
(RUN) when the tape fills.
DEFERIO
indicates that no trace data is recorded on tape until TRSAVE CP OFF is
issued.
FRAMES mmmmm
identifies the amount of real storage frames set aside for an in-storage-wrap of
the DEFERIO trace. The frames have been allocated from the system dynamic
paging area.
FILLED nnnnn
identifies the amount of those real storage frame that have been filled with trace
data. nnnnn will not exceed mmmmm-1 because one frame is set aside as the
current frame being filled. When nnnnn reaches mmmmm-1, the displayed
value remains at that level until TRSAVE CP OFF is issued.
Response 7:
The following message is displayed if TRSAVE FOR CP is not active:
TRSAVE inactive for CP
Response 8:
The following message indicates that TRSAVE FOR CP is neither active nor
inactive, but is in a transition state between the two:
TRSAVE pending active for CP
Response 9:
1050 z/VM: CP Commands and Utilities Reference
The following messages are displayed when a class A, C, or E user issues QUERY
TRSAVE FRAMES.
nnnnnn frames are allocated for active DEFERIO traces.
mmmmmm pages are still eligible to be allocated for DEFERIO traces.