z/VM: CP Commands and Utilities Reference - z/VM - IBM

QUERY TRACE
The following response is to QUERY TRACE RETURNS.
RETURNS: name1, name2,...
name1...
identifies trace sets in the trace return path.
Response 4:
No trace sets defined
is the response for any form of the QUERY TRACE command if no trace sets have
been defined.
Response 5:
No trace calls active
is the response for QUERY TRACE RETURNS if no trace calls are active;
therefore, there are no return paths.
Response 6:
The following responses are to QUERY TRACE ALL, QUERY TRACE ACTIVE, and
QUERY TRACE name.
The current status of all defined trace sets, of trace traps within the active trace set,
or of a specifically identified trace set, is displayed by QUERY TRACE. Each trace
trap has a specific format as shown below where ident is the trace trap identifier for
each trap within the trace set. A common header exists for these responses.
NAME setname [ACTIVE ]
[ACTIVE + SUSPEND]
When the ACTIVE operand is specified, it appears at the top of the list of the active
trace set.
Note that trace entries can be displayed as STO raddr ASN xxx or as ASCE raddr;
the STO or ASCE information may be on a line by itself, depending on the length of
the FROM and INTO information.
Query Trace Examples:
1040 z/VM: CP Commands and Utilities Reference
1 BRANCH FROM 0000000000000000-1111111111111111
INTO 0000022222222222-0000555555555555
TERM NOPRINT NORUN SIM
SKIP 00000 PASS 00000 STOP 00000 STEP 00000
CMD NONE
2 BRANCH FROM 0000000000000000-1111111111111111
STO 00000000 ASN 0000
INTO 0000022222222222-0000555555555555
STO 00000000 ASN 0000
TERM NOPRINT NORUN SIM
SKIP 00000 PASS 00000 STOP 00000 STEP 00000
CMD NONE
3 BRANCH FROM 00000000-00000011 STO 00000000 ASN 0000
INTO 00000222-00005555 STO 00000000 ASN 0000
TERM NOPRINT NORUN SIM
SKIP 00000 PASS 00000 STOP 00000 STEP 00000
CMD NONE
4 STORE FROM 00000000-00000011 STO 00000000 ASN 0000