z/VM: CP Commands and Utilities Reference - z/VM - IBM

Responses
Messages
If query information is not available for at least one device in a range, then a
generic error message will be issued. For example:
query scmeasure 100-102
HCPCHC1003E 0100-0102 was not found
Ready(01003);
Response 1:
To find out whether CP is collecting subchannel measurement data for device 131,
enter the following QUERY SCMEASURE command:
query scmeasure 131
Subchannel measuring for device 0131 is on
Ready;
Response 2:
HCP003E Invalid option - option
To find out which devices CP is collecting subchannel measurement data for in the
device range 750 through 759, enter the following QUERY SCMEASURE
command:
query scmeasure 750-759
Subchannel measuring for device 0750 is off
Subchannel measuring for device 0751 is off
Subchannel measuring for device 0752 is on
Subchannel measuring for device 0753 is on
Subchannel measuring for device 0754 is on
Subchannel measuring for device 0755 is off
Subchannel measuring for device 0756 is on
Subchannel measuring for device 0757 is on
Ready;
This example shows that:
HCP009E Invalid range - rdev-rdev
v CP is not collecting subchannel measurement data for devices 750, 751, and 755
v CP is collecting subchannel measurement data for devices 752, 753, 754, 756,
and 757
HCP021E A real device number was not supplied
or it is invalid.
HCP040E Device rdev does not exist
HCP1003E rdev was not found.
HCP6706E Invalid RDEV - rdev. RDEV not
initialized
QUERY SCMEASURE
Chapter 2. CP Commands 985