Development of a Cold Gas Propulsion System for the ... - SSL - MIT

More documents

Recommendations

Info

4.1.2 Rocket Propulsion Equations Like all forms of rocket propulsion, a cold gas thruster produces thrust by converting the internal energy of a gas to kinetic energy in an exhaust flow by means of thermodynamic expansion in a nozzle [28]. As propellant mass is ejected from the thruster at high speeds in the exhaust flow, thrust is produced in the opposite direction to ensure conservation of momentum for the system. Thrust is also produced by any difference between the exhaust pressure and the ambient pressure. In equation form:
variables in equation (4-8) deal with the thermodynamic state of the gas in the thruster chamber. For
Page 1: Development of a Cold Gas Propulsio
Page 5: Abstract The TALARIS (Terrestrial A
Page 9 and 10: Table of Contents List of Figures .
Page 11: 7 Ongoing and Future Work .........
Page 14 and 15: Figure 6-6. Identification of thrus
Page 17 and 18: Notation Acronyms and Abbreviations
Page 19 and 20: N newton Pa pascal psi pounds per s
Page 21 and 22: 1 Introduction The TALARIS (Terrest
Page 23 and 24: the idea of hopping was born, and i
Page 25 and 26: However, as stated before, this doe
Page 27 and 28: Figure 2-3. Diagram of ACAT lander
Page 29 and 30: An alternate approach to resolving
Page 31 and 32: accurate conditions for testing GNC
Page 33 and 34: Ballistic hops tend to use less pro
Page 35 and 36: 2.3.2 Comparison of Cold Gas and Mo
Page 37 and 38: Handling propellant There are sever
Page 39 and 40: and if the cold gas system was foun
Page 41 and 42: 3 TALARIS CGSE Design Framework Aft
Page 43 and 44: Figure 3-1. Scaling of TALARIS terr
Page 45 and 46: (3) Providing attitude control Ther
Page 47 and 48: Figure 3-2 also shows the body coor
Page 49 and 50: 4 Modeling and Flow Control Compone
Page 51: 4.1.2 Rocket Propulsion Equations L
Page 55 and 56: equations. Equation (4-10) was then
Page 57 and 58: that of helium (0.227 MPa = 32.9 ps
Page 59 and 60: thruster solenoid valve, and chambe
Page 61 and 62: where
Page 63 and 64: discussed later in section 6.3.4, t
Page 65 and 66: The flight profile begins with maxi
Page 67 and 68: hop, any given valve or regulator o
Page 69 and 70: esponse time was an important perfo
Page 71 and 72: directly opens and closes the main
Page 73 and 74: If 1D isentropic flow is assumed, t
Page 75 and 76: 5 Single-Stream Component Testing A
Page 77 and 78: the solenoid valve, and a pressure
Page 79 and 80: As indicated in Figure 5-3, initial
Page 81 and 82: Figure 5-5. CGSE high side as const
Page 83 and 84: Figure 5-7 illustrates several aspe
Page 85 and 86: 6 Full Eight-Thruster Flight System
Page 87 and 88: Figure 6-2. TALARIS CGSE assembled
Page 89 and 90: stream tests revealed that changes
Page 91 and 92: Figure 6-5. Original CGSE control c
Page 93 and 94: other constraints. This was difficu
Page 95 and 96: variables (such as number of thrust
Page 97 and 98: One solution to this problem would
Page 99 and 100: One of the characterization tests w
Page 101 and 102: or more thrusters were firing toget
Page 103 and 104:
Table 6-3. Valve timing metrics dur
Page 105 and 106:
Figure 6-11. Redesigned CGSE contro
Page 107 and 108:
The imaginary simplified thruster c
Page 109 and 110:
traverse phase of a hop and involve
Page 111 and 112:
Figure 7-3. GNC data from 3-DOF tes
Page 113 and 114:
Tests on this vertical stand demons
Page 115 and 116:
control the belay line can be put u
Page 117 and 118:
accounting for changes in thrust le
Page 119 and 120:
development under the supervision o
Page 121 and 122:
documenting progress takes time whi
Page 123 and 124:
were encountered, it was harder to
Page 125 and 126:
[10] Bryant, K. M., Knight, C. J.,
Page 127 and 128:
[31] Canadian Centre for Occupation
Page 129 and 130:
[50] ISA - The Instrumentation, Sys
show all

Development of a Cold Gas Propulsion System for the ... - SSL - MIT

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?