Installation

CHECKLIST FOR 6-WIRE INSTALLATION
All the information required for a 6-wire installation is contained in the various sections of
this manual.
Below is a summary of items that need to be addressed for 6-wire operation.
1. Fit wire link between COM1 and MUS1 (at Master only).
2. Fit wire link between COM2 and MUS2 (at Master only).
3. Fit shunt across jumper “L1” on Audio PCB in Master labelled “AUXILIARY INPUT
BOARD”.
4. Leave Master programmed to “8-wire”.
5. Program each Room Station to “6-wire” as follows:
- Enter Program Mode by pressing the “PRIV” and “MON” buttons at the same time.
- Toggle between 6-wire and 8-wire modes by pressing the “HOUSE” button.
- Green L.E.D. on indicates 8-wire mode.
- Green L.E.D. off indicates 6-wire mode.
- Press “CAN” (CANCEL) button to exit program mode and lock in selection.
6. Wire Auxiliary Input Type B (if fitted) according to 6-wire instructions and ensure
shunt is fitted so as to bridge Link “L1”.
89