Installation

Recommendations

Info

Radio Dialler The Radio Dialler initiates the following events. Program Option Event Code (XYZ) Offset and device ID or Always enabled 355 Radio supervision poll fail (Dialler) Type number (CCC) 103 Always enabled 302 Dialler unit battery low 101 Always enabled 301 Mains Fail Radio Dialler 102 Restores are not sent for the following: 130 Burglary 133 24 hour 355 Radio jamming 120 Panic 121 Duress The message 406 "Cancel" is sent only as a restore (Q=3). 67
VOICE MESSAGES & OPTIONS Voice annunciation can be independently enabled/disabled for each of the following categories. Note that there is no voice annunciation available in PROGRAM mode. Messages are annunciated only when triggered by a user, either by pressing the "OFF" button, or when the main PIR is triggered (once only, for a new message). For details of “chirp” responses, and complete list of voice messages, see appropriate sections elsewhere in this document. Category When Chirp and/or Voice response 1. Status (ARMED, DISARMED etc) Entering ARMED mode: Voice disabled Voice enabled Start of exit delay chirp “Armed” End of exit delay chirp chirp Entering HOME/HOME 2 mode: Start of exit delay chirp “HOME [or HOME 2] armed”, no external chirps even if enabled End of exit delay chirp chirp Disarming from ARMED mode chirp “Disarmed” Disarming from HOME/HOME 2 mode chirp “Disarmed”, no external chirps even if enabled 68
Page 1 and 2:
HOME COMMUNICATION EQUIPMENT SYSTEM
Page 3 and 4:
INSTALLATION OF VF103 DOOR STATIONS
Page 5 and 6:
VR102 ROOM STATION ADJUSTMENTS.....
Page 7 and 8:
LOCATION OF EQUIPMENT MASTER STATIO
Page 9 and 10:
AUXILIARY/LOCK OUTPUT BOARD The Aux
Page 11 and 12:
AM AERIAL The coaxial cable supplie
Page 13 and 14:
BLOCK DIAGRAM FOR SYSTEM WITH MASTE
Page 15 and 16:
INSTALLATION OF MASTER STATION TIMB
Page 17 and 18:
Mounting Brackets for Tamper Switch
Page 19 and 20:
CABLE TERMINATIONS FOR VM102-S MAST
Page 21 and 22: FM AM POWER SUPPLY 13.8V BATT IP NE
Page 23 and 24: INSTALLATION OF VR102 ROOM STATIONS
Page 25 and 26: CABLE TERMINATION FOR VR102 ROOM ST
Page 27 and 28: CABLE TERMINATION FOR VR102 ROOM ST
Page 29 and 30: CABLE TERMINATION FOR VF 103 DOOR S
Page 31 and 32: WIRING VOLTAGE OUTPUTS The Lock out
Page 33 and 34: Operating Automatic Gates AUTO GATE
Page 35 and 36: 4-Wire Operation If only four wires
Page 37 and 38: CABLE TERMINATION FOR VF102 DOOR ST
Page 39 and 40: INSTALLATION OF AUXILIARY INPUT JAC
Page 41 and 42: INSTALLATION OF WIRELESS AUDIO TRAN
Page 43 and 44: INSTALLATION OF POWER SUPPLY A regu
Page 45 and 46: POWERING UP THE SYSTEM For the VM10
Page 47 and 48: VM102 MASTER STATION PROGRAMMING To
Page 49 and 50: VM102 MASTER STATION ADJUSTMENTS SE
Page 51 and 52: PROGRAMMING SECURITY FEATURES (DETA
Page 53 and 54: Home Press the "ON" button two time
Page 55 and 56: KEY TYPES User Key ��3-button p
Page 57 and 58: DISPLAY DESCRIPTION PANIC < KEY, BU
Page 59 and 60: DIALER < RADIO < FAIL DIALER < POWE
Page 61 and 62: PROGRAMMING VM102-SECURE uses a com
Page 63 and 64: PROGRAMMING RADIO DIALLER Local Pro
Page 65 and 66: SENS 2-23 DETECTOR 2-23 (default =
Page 67 and 68: LOKOUT DETECTOR LOCKOUT (default =
Page 69 and 70: PHONE2 PHONE NUMBER 2 (default = -)
Page 71: Main Unit The following events are
Page 75 and 76: Category When Chirp and/or Voice re
Page 77 and 78: IMPORTANT NOTES: To place the VM102
Page 79 and 80: VR102 ROOM STATION PROGRAMMING To a
Page 81 and 82: VR102 ROOM STATION ADJUSTMENTS MICR
Page 83 and 84: CHANGING THE CHIME The chime melody
Page 85 and 86: WIRING VOLTAGE OUTPUTS The Lock out
Page 87 and 88: CHANGING THE CHIME The chime melody
Page 89 and 90: SETTING UP INPUT JACK TYPE B If the
Page 91 and 92: SYSTEM ONE - TERMINAL FUNCTIONS POS
Page 93 and 94: AUX ��Outputs specific voltage
Page 95: TROUBLE SHOOTING Fault: Volume Cont
show all

Installation

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?