Installation
Installation
Installation
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SIGNAL SIGNAL CHECK: Check signal strength of radio detectors and keys<br />
VM102-Secure registers the first device received and displays the signal strength (1-9),<br />
and beeps a corresponding number of times.<br />
��Press "ON" to activate Signal Check - display shows “SEND DEVICE”<br />
��For a key, press PANIC; for a detector, activate the detector<br />
��Listen to beeps, view display<br />
��Press "OFF" to exit Signal Check<br />
��Press "ON" to re-activate Signal Check<br />
-- No detectors received<br />
SENS 2-23 Detector x received<br />
KEY 1-23 Key x received<br />
1-9 Signal strength<br />
RADJAM RADIO JAMMING (default = OFF)<br />
In the event of a VM102-Secure sensing a continuous (>30 secs) source of Radio<br />
Frequency Interference (RFI), it can generate a CHIME alarm in DISARMED, HOME or<br />
HOME 2 modes, and a full alarm in ARMED mode.<br />
ON Enabled<br />
OFF Disabled<br />
RADSUB RADIO INTENTIONAL MESSAGE SUBSTITUTION (default = OFF)<br />
In the event of a VM102-Secure sensing a radio message with a recognised device ID but<br />
failing decryption, it can generate a CHIME alarm in DISARMED, HOME or HOME 2<br />
modes, and a full alarm in ARMED mode.<br />
ON Enabled<br />
OFF Disabled<br />
SUPVIS SUPERVISION STATUS (default = 8)<br />
Non-supervised devices: If enabled, a system alarm will occur if the detector has not<br />
triggered for 20 ARM/DISARM operations. The count starts after the device’s first<br />
transmission following PROGRAM mode exit. If the warning is ignored, the display will<br />
Supervised devices: If enabled, a system alarm will occur if a valid supervisory message<br />
has not been received from the detector within the period set in this option. Supervised<br />
devices send a poll message every hour (with a random offset factor of +/- 2 minutes to<br />
eliminate collisions). If the main system does not receive a signal for X consecutive hours,<br />
a warning will be displayed.<br />
1,4,8,16,24 Supervision alarm occurs if no supervisory message is received within set<br />
period (in hours)<br />
OFF Supervision alarms disabled<br />
61