Installation

SENS 2-23 DETECTOR 2-23 (default = ALARM)
To learn a new detector:
With display showing "LEARN"
For encrypted restoring detector (e.g. reed switch):
��Power the detector off and back on again, by momentarily disconnecting the battery,
with the reed switch "closed," to enable "CHECK mode" operation, and the
reed "open" to disable "CHECK mode" operation. The VM102-Secure gives 2
beeps and flashes "SENS 2-23" when the code is accepted.
For encrypted non-restoring detector:
��Power the detector off and back on again by momentarily disconnecting the battery.
The VM102-Secure gives 2 beeps and flashes "SENS 2-23" when the code is
accepted.
ALARM ALARM Active when ARMED, inactive when DISARMED
HOME HOME Active when ARMED or HOME modes
HOME 2 HOME 2 Active when ARMED & HOME 2 modes
FIRE FIRE 24 hour alarm, always active.
CHIME CHIME Chime* when DISARMED, inactive when ARMED,
HOME or HOME 2 modes
ACHIME ALARM/CHIME Alarm when ARMED, chime** when DISARMED,
inactive when in HOME or HOME 2 modes
HCHIME HOME/CHIME Alarm when ARMED mode, chime** when in HOME or
HOME 2 modes, inactive when DISARMED
H2CHIM HOME 2 CHIME Alarm when ARMED mode, chime** when in HOME
or HOME 2 modes, inactive when DISARMED
ERASE ERASE Detector is erased
(*) Chime tone
(**) Warning tone
RANGE DETECTOR RANGE (default = LOW)
LOW Low range 8m
HIGH High range 14m
NOTE: OK light turns on each time PIR is activated.
PULSE DETECTOR PULSE COUNT (default = 3)
1-4 Number of times (1-4) a detection beam needs to crossed before an
alarm occurs
NOTE: OK light turns on each time PIR is activated.
60