Installation
Installation
Installation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Configuring Devices and Options<br />
In PROGRAM mode, the display remains steady when displaying devices (programmed<br />
keys and detectors) and system options (EXIT TIME etc). The display flashes when<br />
displaying the current programmed value for each device or option. Various beeps give<br />
audible feedback during the programming process.<br />
��Press "OFF" (on a programmed key) to step through the devices and options.<br />
��Press "ON" to view the value for that option (flashing). Press the "ON" button again<br />
to step through alternative values (non flashing).<br />
��Press the PANIC button to store the displayed value (causing it to flash).<br />
��Press "OFF" to step to next device/option.<br />
Programming Notes<br />
Program stepping requires a programmed key.<br />
Each time a programming change is made, the new value will be flashing and is stored<br />
immediately in non-volatile memory.<br />
A programmed device can be erased, by selecting ERASE. The display will then show<br />
LEARN, giving the user the option of reprogramming a new device into this particular slot.<br />
This allows a faulty device to be replaced while keeping the same slot number.<br />
VM102-Secure will flash FULL if an attempt is made to program a device when there are<br />
no more slots available. It will allow programmed devices to be viewed in sequence and<br />
erased if desired.<br />
A key cannot be used to erase itself. A device cannot be programmed more than once.<br />
The VM102-Secure will give a long warning beep if either of the above is attempted.<br />
The VM102-Secure will automatically exit PROGRAM mode after 10 minutes of inactivity.<br />
57