Installation

PROGRAMMING SECURITY FEATURES (QUICK GUIDE)
1) Fit 2-way jumper to alarm PCB to enter “LEARN” mode.
2) Version number followed by alternating “LEARN” and “KEY 1” will appear on display.
3) Press and hold “PANIC” button on remote key fob.
4) A single bell followed by two double bells will be heard.
5) “KEY 1” will flash on display.
6) Press “DISARM” button on key fob to select “LEARN.”
7) Press “ARM” button on key fob to select “READY.”
8) Press and hold “PANIC” button on 2nd key fob.
9) A single bell followed by two double bells will be heard.
10) “KEY 2” will flash on display.
11) Press “DISARM” button on key fob to select “LEARN.”
12) Press “ARM” button on key fob to select “READY.”
13) Select “LEARN” and “READY” modes with key fob as above, to program additional key fobs.
14) These will appear as “KEY 3”, “KEY 4”, etc.
15) To program sensors, connect battery to sensor while Master is in “READY” mode.
16) Select “LEARN” and “READY” modes with key fob as above to program additional
wireless sensors.
17) These will appear as “SENS 1”, “SENS 2” etc.
18) Press “DISARM” button repeatedly to scroll through the various options for programming.
19) Press “ARM” button to view current setting.
20) Repeatedly press “ARM” button to view optional settings.
21) Press and hold “PANIC” button to select new setting.
22) Use “DISARM” button to scroll through remaining options.
23) When “P-EXIT” appears on display, Press “ARM” button to exit program mode.
24) Voice message will be heard: “Warning outside siren tamper fault."
Display will read: “Siren tamper excluded XX hrs XX min ago.”
This is because the tamper switch on the fascia is unsealed.
25) Press the “DISARM” button on the key fob to clear message.
26) Press and release the Lid tamper switch to test tamper circuit. Siren should sound from
Master and message should scroll across display.
27) Press the "DISARM" button on the key fob repeatedly until message clears.
28) While arming and disarming using remote key fob, adjust VR1 on Master termination
PCB to set the security voice volume level.
NOTE: This adjustment will also affect the siren volume level from the Master and
Room Stations and should be set as loud as tolerable.
45