Installation
Installation
Installation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
POWERING UP THE SYSTEM<br />
For the VM102-S with wireless security, remove the shunt from the 2-way header at the<br />
bottom of the security PCB, located in the top left hand corner of the Master fascia<br />
(looking from the rear).<br />
For the VM102-S with wireless security, ensure that the 12V battery is not connected.<br />
For all systems, ensure all the stations and accessories have been installed and correctly<br />
terminated.<br />
Plug the power supply into a power point and turn the power point on.<br />
If the power supply is fitted with its own power switch, turn the switch on.<br />
If the system is fitted with a Master, the radio/clock should illuminate.<br />
For a Room Station only system, press the house talk button at any Room Station,<br />
checking that the green L.E.D. turns on while the button is being pressed.<br />
With a multimeter, measure the DC voltage, at the terminals to which the power supply are<br />
connected.<br />
The measured voltage should be between 13.2 and 14.2 Volts DC.<br />
If the voltage measures low, or the displays and L.E.D.s are not working, turn the power<br />
supply off immediately. Identify and correct the fault before proceeding any further.<br />
If everything appears to be in order, and the system is fitted with a VM102-S Master with<br />
security, connect the battery ensuring that the polarity is correct.<br />
The small lamp on the left side of the termination PCB may glow dimly indicating that the<br />
battery is being charged.<br />
If the lamp glows very brightly, there is a problem that needs to be rectified.<br />
40