Installation
Installation Installation
INSTALLATION OF VF102 DOOR STATIONS These stations are best located adjacent to the front door or at the front gate at a suggested height of 1400 millimetres and will require either a surface mount wall box or a flush mount wall box depending on the mounting surface and personal preference. Any Station exposed to the weather will require the fitting of a weatherproof cover. Where stations are to be installed in solid brick or concrete columns at a front gate, it is required that the cable be run in conduit from the station to below ground level and back to the house. When using 8-wire cable to connect to the Door Station, do not connect the two spare wires to the MUS1 and MUS2 terminals at the Master Station (or Room Station) end of the cable. The two spare wires from an 8-wire cable may be wired in parallel to the POS and NEG wires to the gate station, to double the maximum cable distance to a length of 200 metres. Where a Door Station is part of a wiring loop, the Door Station should generally be the last station on the loop. CABLE TERMINATION FOR VF 102 DOOR STATION Using Valet Cable RED BLACK WHITE BLUE Green and Orange to be taped back at this end and also at other end. POS NEG COM1 COM2 U5 VR1 VR2 GREEN ORANGE VR3 TC VLC SHLD CH SEL PROG NOTE: RESISTANCE OF RELAY COIL SHOULD BE 240 OHM OR GREATER SHIELDED RED SHIELDED WHITE OUTER SHIELD 12V RELAY COIL N-O NOTE: Outer shield should be insulated. POS NEG OPTIONAL * ADDITION Mech Chime 31
CABLE TERMINATION FOR VF102 DOOR STATION Using Cat 5 Cable BROWN BROWN/WH GREEN GREEN/WH Orange and Orange/White to be taped back at this end and also at other end. POS NEG COM1 COM2 U5 VR1 VR2 ORANGE ORANGE/WHITE VR3 TC VLC SHLD CH SEL PROG NOTE: RESISTANCE OF RELAY COIL SHOULD BE 240 OHM OR GREATER CABLE TERMINATION FOR VF102 DOOR STATION Using 6 Wire Telephone Cable RED BLACK WHITE BLUE POS NEG COM1 COM2 U5 VR1 VR2 VR3 TC VLC SHLD CH SEL PROG NOTE: RESISTANCE OF RELAY COIL SHOULD BE 240 OHM OR GREATER BLUE BLUE/WHITE 12V RELAY POS COIL N-O GREEN ORANGE 12V RELAY NEG POS COIL N-O NEG * * OPTIONAL ADDITION Mech Chime OPTIONAL ADDITION Mech Chime 32
- Page 1 and 2: HOME COMMUNICATION EQUIPMENT SYSTEM
- Page 3 and 4: INSTALLATION OF VF103 DOOR STATIONS
- Page 5 and 6: VR102 ROOM STATION ADJUSTMENTS.....
- Page 7 and 8: LOCATION OF EQUIPMENT MASTER STATIO
- Page 9 and 10: AUXILIARY/LOCK OUTPUT BOARD The Aux
- Page 11 and 12: AM AERIAL The coaxial cable supplie
- Page 13 and 14: BLOCK DIAGRAM FOR SYSTEM WITH MASTE
- Page 15 and 16: INSTALLATION OF MASTER STATION TIMB
- Page 17 and 18: Mounting Brackets for Tamper Switch
- Page 19 and 20: CABLE TERMINATIONS FOR VM102-S MAST
- Page 21 and 22: FM AM POWER SUPPLY 13.8V BATT IP NE
- Page 23 and 24: INSTALLATION OF VR102 ROOM STATIONS
- Page 25 and 26: CABLE TERMINATION FOR VR102 ROOM ST
- Page 27 and 28: CABLE TERMINATION FOR VR102 ROOM ST
- Page 29 and 30: CABLE TERMINATION FOR VF 103 DOOR S
- Page 31 and 32: WIRING VOLTAGE OUTPUTS The Lock out
- Page 33 and 34: Operating Automatic Gates AUTO GATE
- Page 35: 4-Wire Operation If only four wires
- Page 39 and 40: INSTALLATION OF AUXILIARY INPUT JAC
- Page 41 and 42: INSTALLATION OF WIRELESS AUDIO TRAN
- Page 43 and 44: INSTALLATION OF POWER SUPPLY A regu
- Page 45 and 46: POWERING UP THE SYSTEM For the VM10
- Page 47 and 48: VM102 MASTER STATION PROGRAMMING To
- Page 49 and 50: VM102 MASTER STATION ADJUSTMENTS SE
- Page 51 and 52: PROGRAMMING SECURITY FEATURES (DETA
- Page 53 and 54: Home Press the "ON" button two time
- Page 55 and 56: KEY TYPES User Key ��3-button p
- Page 57 and 58: DISPLAY DESCRIPTION PANIC < KEY, BU
- Page 59 and 60: DIALER < RADIO < FAIL DIALER < POWE
- Page 61 and 62: PROGRAMMING VM102-SECURE uses a com
- Page 63 and 64: PROGRAMMING RADIO DIALLER Local Pro
- Page 65 and 66: SENS 2-23 DETECTOR 2-23 (default =
- Page 67 and 68: LOKOUT DETECTOR LOCKOUT (default =
- Page 69 and 70: PHONE2 PHONE NUMBER 2 (default = -)
- Page 71 and 72: Main Unit The following events are
- Page 73 and 74: VOICE MESSAGES & OPTIONS Voice annu
- Page 75 and 76: Category When Chirp and/or Voice re
- Page 77 and 78: IMPORTANT NOTES: To place the VM102
- Page 79 and 80: VR102 ROOM STATION PROGRAMMING To a
- Page 81 and 82: VR102 ROOM STATION ADJUSTMENTS MICR
- Page 83 and 84: CHANGING THE CHIME The chime melody
- Page 85 and 86: WIRING VOLTAGE OUTPUTS The Lock out
CABLE TERMINATION FOR VF102 DOOR STATION<br />
Using Cat 5 Cable<br />
BROWN<br />
BROWN/WH<br />
GREEN<br />
GREEN/WH<br />
Orange and Orange/White to be taped<br />
back at this end and also at other end.<br />
POS<br />
NEG<br />
COM1<br />
COM2<br />
U5<br />
VR1<br />
VR2<br />
ORANGE<br />
ORANGE/WHITE<br />
VR3<br />
TC<br />
VLC<br />
SHLD<br />
CH<br />
SEL<br />
PROG<br />
NOTE: RESISTANCE OF RELAY COIL<br />
SHOULD BE 240 OHM OR GREATER<br />
CABLE TERMINATION FOR VF102 DOOR STATION<br />
Using 6 Wire Telephone Cable<br />
RED<br />
BLACK<br />
WHITE<br />
BLUE<br />
POS<br />
NEG<br />
COM1<br />
COM2<br />
U5<br />
VR1<br />
VR2<br />
VR3<br />
TC<br />
VLC<br />
SHLD<br />
CH<br />
SEL<br />
PROG<br />
NOTE: RESISTANCE OF RELAY COIL<br />
SHOULD BE 240 OHM OR GREATER<br />
BLUE<br />
BLUE/WHITE<br />
12V<br />
RELAY<br />
POS<br />
COIL N-O<br />
GREEN<br />
ORANGE<br />
12V<br />
RELAY<br />
NEG<br />
POS<br />
COIL N-O<br />
NEG<br />
*<br />
*<br />
OPTIONAL<br />
ADDITION<br />
Mech<br />
Chime<br />
OPTIONAL<br />
ADDITION<br />
Mech<br />
Chime<br />
32