Installation

INSTALLATION OF VF102 DOOR STATIONS
These stations are best located adjacent to the front door or at the front gate at a
suggested height of 1400 millimetres and will require either a surface mount wall box or a
flush mount wall box depending on the mounting surface and personal preference.
Any Station exposed to the weather will require the fitting of a weatherproof cover.
Where stations are to be installed in solid brick or concrete columns at a front gate, it is
required that the cable be run in conduit from the station to below ground level and back to
the house.
When using 8-wire cable to connect to the Door Station, do not connect the two spare
wires to the MUS1 and MUS2 terminals at the Master Station (or Room Station) end of the
cable.
The two spare wires from an 8-wire cable may be wired in parallel to the POS and NEG
wires to the gate station, to double the maximum cable distance to a length of 200 metres.
Where a Door Station is part of a wiring loop, the Door Station should generally be the last
station on the loop.
CABLE TERMINATION FOR VF 102 DOOR STATION
Using Valet Cable
RED
BLACK
WHITE
BLUE
Green and Orange to be taped back
at this end and also at other end.
POS
NEG
COM1
COM2
U5
VR1
VR2
GREEN
ORANGE
VR3
TC
VLC
SHLD
CH
SEL
PROG
NOTE: RESISTANCE OF RELAY COIL
SHOULD BE 240 OHM OR GREATER
SHIELDED RED
SHIELDED WHITE
OUTER SHIELD
12V
RELAY
COIL N-O
NOTE: Outer shield should
be insulated.
POS
NEG
OPTIONAL
*
ADDITION
Mech
Chime
31