Installation
Installation Installation
4 AND 5 WIRE DOOR STATION OPERATION There will be instances where not all of the six wires normally required for operation will be available. 5-Wire Operation If only five wires are available from the Door Station, the “TC” line may be omitted. Where the “TC” line has been omitted, a diode must be added across the “TC” and “VLC” terminals at the Master or Room Station to which the cable from the front Door Station is connected. Placement of Diode For 5-Wire Operation MASTER STATION SHLD VLC TC NEG POS DIODE MUS1 COM2 COM1 AUX MUS2 ROOM STATION AUX MUS2 MUS1 COM2 COM1 SHLD VLC TC NEG POS NOTE: CATHODE (STRIPED END) OF DIODE CONNECTS TO “TC” DIODE 29
4-Wire Operation If only four wires are available from the Door Station, the “COM2” line may be omitted in addition to the “TC” line. Where the “COM2” line has been omitted, there will be a reduction in microphone and speaker volume, which can be compensated for, by turning up the microphone and speaker gain at the Door Station. NOTE: Omitting the “COM2” line may reduce immunity to RF interference. Fitting capacitors at the Door Station and at the Room Station, to which the cable from the front Door Station is connected, will compensate for this to some extent. Placement of Capacitors For 4 Wire Operation COM1 COM2 102 CAPACITORS # COM1 COM2 # 1 nF MONOLITHIC OR CERAMIC (102 MARKING) 102 30
- Page 1 and 2: HOME COMMUNICATION EQUIPMENT SYSTEM
- Page 3 and 4: INSTALLATION OF VF103 DOOR STATIONS
- Page 5 and 6: VR102 ROOM STATION ADJUSTMENTS.....
- Page 7 and 8: LOCATION OF EQUIPMENT MASTER STATIO
- Page 9 and 10: AUXILIARY/LOCK OUTPUT BOARD The Aux
- Page 11 and 12: AM AERIAL The coaxial cable supplie
- Page 13 and 14: BLOCK DIAGRAM FOR SYSTEM WITH MASTE
- Page 15 and 16: INSTALLATION OF MASTER STATION TIMB
- Page 17 and 18: Mounting Brackets for Tamper Switch
- Page 19 and 20: CABLE TERMINATIONS FOR VM102-S MAST
- Page 21 and 22: FM AM POWER SUPPLY 13.8V BATT IP NE
- Page 23 and 24: INSTALLATION OF VR102 ROOM STATIONS
- Page 25 and 26: CABLE TERMINATION FOR VR102 ROOM ST
- Page 27 and 28: CABLE TERMINATION FOR VR102 ROOM ST
- Page 29 and 30: CABLE TERMINATION FOR VF 103 DOOR S
- Page 31 and 32: WIRING VOLTAGE OUTPUTS The Lock out
- Page 33: Operating Automatic Gates AUTO GATE
- Page 37 and 38: CABLE TERMINATION FOR VF102 DOOR ST
- Page 39 and 40: INSTALLATION OF AUXILIARY INPUT JAC
- Page 41 and 42: INSTALLATION OF WIRELESS AUDIO TRAN
- Page 43 and 44: INSTALLATION OF POWER SUPPLY A regu
- Page 45 and 46: POWERING UP THE SYSTEM For the VM10
- Page 47 and 48: VM102 MASTER STATION PROGRAMMING To
- Page 49 and 50: VM102 MASTER STATION ADJUSTMENTS SE
- Page 51 and 52: PROGRAMMING SECURITY FEATURES (DETA
- Page 53 and 54: Home Press the "ON" button two time
- Page 55 and 56: KEY TYPES User Key ��3-button p
- Page 57 and 58: DISPLAY DESCRIPTION PANIC < KEY, BU
- Page 59 and 60: DIALER < RADIO < FAIL DIALER < POWE
- Page 61 and 62: PROGRAMMING VM102-SECURE uses a com
- Page 63 and 64: PROGRAMMING RADIO DIALLER Local Pro
- Page 65 and 66: SENS 2-23 DETECTOR 2-23 (default =
- Page 67 and 68: LOKOUT DETECTOR LOCKOUT (default =
- Page 69 and 70: PHONE2 PHONE NUMBER 2 (default = -)
- Page 71 and 72: Main Unit The following events are
- Page 73 and 74: VOICE MESSAGES & OPTIONS Voice annu
- Page 75 and 76: Category When Chirp and/or Voice re
- Page 77 and 78: IMPORTANT NOTES: To place the VM102
- Page 79 and 80: VR102 ROOM STATION PROGRAMMING To a
- Page 81 and 82: VR102 ROOM STATION ADJUSTMENTS MICR
- Page 83 and 84: CHANGING THE CHIME The chime melody
4 AND 5 WIRE DOOR STATION OPERATION<br />
There will be instances where not all of the six wires normally required for operation will be<br />
available.<br />
5-Wire Operation<br />
If only five wires are available from the Door Station, the “TC” line may be omitted.<br />
Where the “TC” line has been omitted, a diode must be added across the “TC” and “VLC”<br />
terminals at the Master or Room Station to which the cable from the front Door Station is<br />
connected.<br />
Placement of Diode For 5-Wire Operation<br />
MASTER<br />
STATION<br />
SHLD<br />
VLC<br />
TC<br />
NEG<br />
POS<br />
DIODE<br />
MUS1<br />
COM2<br />
COM1<br />
AUX<br />
MUS2<br />
ROOM<br />
STATION<br />
AUX<br />
MUS2<br />
MUS1<br />
COM2<br />
COM1<br />
SHLD<br />
VLC<br />
TC<br />
NEG<br />
POS<br />
NOTE: CATHODE (STRIPED END) OF DIODE CONNECTS TO “TC”<br />
DIODE<br />
29