Installation

Mounting Brackets for Tamper Switch and Lid
TOP MOUNTING
BRACKET
TAMPER
SWITCH
TAMPER
BRACKET
FIT TO RIGHT
HAND SCREW
CONNECTING THE WIRING
EXPLODED VIEW ASSEMBLED VIEW
BOTTOM MOUNTING
BRACKET
Strip back approximately 150mm of white insulation from all the Valet intercom cables.
Group the wires together according to their colours and trim to equal length.
Strip back approximately 30mm off the end of each of the individual coloured wires and
twist the bared wires together according to their colours.
Twist the outer shield from each of the Valet cables together and insulate with heat-shrink
or spaghetti tubing leaving the final 30mm exposed.
Cut nine 120mm sections of heavy-duty hook-up cable (24 x 0.2mm)
Strip 30mm of insulation from one end of each of these sections.
Twist one of these sections to each of the coloured groups of intercom cable and one to all
the outer shields.
Solder and insulate the connections.
Strip 6mm off the other end of each of the hook-up cables; firmly twist the wire and screw
into the appropriate terminals on the Master termination PCB.
Terminate Antennas, Power Supply, Security and Auxiliary Control wires, where applicable.
Auxiliary Input Jack wires should be grouped with the rest of the intercom cables.
12