02.10.2022 Views

Automotive Electrical and Electronic Systems Classroom Manual Fifth Edition Update by John F. Kershaw

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

www.TechnicalBooksPDF.com

126 Chapter Six

Review Questions

1. Which of the following is not considered

part of the primary wiring system of an

automobile?

a. Spark plug cables

b. Lighting circuits

c. Accessory wiring circuits

d. Power distribution circuits

2. Automotive wiring, or circuit conductors,

exist as all of the following, except:

a. Single-strand wire

b. Multistrand wire

c. Printed circuitry

d. Enameled chips

3. Which of the following wires are known as

suppression cables?

a. Turn signal wiring

b. Cables from the battery to the starter

motor

c. Cables from the distributor cap to the

spark plugs

d. Wiring harnesses from the fuse panel to

the accessories

4. High-resistance ignition cables are used to

do all of the following, except:

a. Reduce radio frequency interference

b. Provide extra resistance to reduce

current flow to the spark plugs

c. Provide more current to the distributor

d. Boost the voltage being delivered to the

spark plugs

5. One of the most common wear points in an

automobile electrical system is:

a. At the ground connecting side

b. The point where a wire has been bent

c. Where two connectors have been

joined

d. At a Maxifuse connection

6. The symbol below indicates which of these:

7. Which of the following is not a term used to

describe an automobile wiring system?

a. Hot-return system

b. Single-wire system

c. Ground-return system

d. Negative-ground system

8. For easy identification, ground wires on

most automotive electrical systems are

color-coded:

a. Red

b. White

c. Black

d. Brown

9. Which of the following is not used to switch

current flow?

a. Relay

b. Solenoid

c. Transistor

d. Coil Windings

10. Two separate windings are used in starter

solenoids to:

a. Increase resistance in the circuit

b. Decrease resistance in the circuit

c. Increase current being drawn from the

battery

d. Decrease current being drawn from the

battery

11. Which of the following reverses the flow of

current through the conductor of a motor?

a. The armature

b. The terminals

c. The field coils

d. The commutator

12. The symbol shown below is for which of

these:

a. Battery

b. Capacitor

c. Diode

d. Ground

a. Fuse

b. Relay

c. Motor

d. Resistor

13. Which of the following is NOT used to protect

a circuit from too much current flow?

a. Fuse

b. Buss bar

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!