TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>TT</strong>-<strong>3000E</strong> <strong>mini</strong>-C <strong>GMDSS</strong> <strong>User</strong> <strong>Manual</strong><br />
5.2.1 POWER ON<br />
Before doing the following steps, you should check that<br />
communication port 1 (Com 1) of your PC or Message<br />
Terminal is connected to the transceiver.<br />
Message Terminal Turn on the power to have the start-up<br />
screen presented.<br />
CAPSAT<br />
Version 3.40 05-12-01<br />
(C) Thrane & Thrane<br />
1. Wait for start-up screen to disappear within 5<br />
seconds and the Capsat window is shown. The<br />
upper left corner of the screen (Status Field)<br />
will show “Transceiver not connected”.<br />
2. Turn on the power of the transceiver and wait<br />
approximately 25 seconds until the power-on<br />
sequence h<strong>as</strong> been completed. The upper left<br />
corner of the screen will now show 'Logged<br />
out', if this is the very first power-on of the<br />
unit.<br />
3. Continue with the next chapter<br />
Commissioning.<br />
38
Change language