TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>TT</strong>-<strong>3000E</strong> <strong>mini</strong>-C <strong>GMDSS</strong> <strong>User</strong> <strong>Manual</strong><br />
acknowledged immediately). It is recommended to use<br />
Distress Test mode to become familiar with the sound and<br />
light indications.<br />
4.2 OTHER BUZZER INDICATIONS<br />
Apart from the alerting signal described above, the buzzer<br />
and lights on the alarm panel have two other purposes:<br />
1. Indicating incoming EGCs or messages with<br />
distress or urgency priority.<br />
2. Indicating printer or hardware problems that may<br />
cause the installation not to work.<br />
The EGC/message signal is a quick beeping sound - around<br />
one beep per second, and the “Distress MSG” light will fl<strong>as</strong>h<br />
at the same rate. This indication can be reset by the<br />
following procedure:<br />
1. Select “Clear distress indication” from the Distress<br />
menu on the <strong>TT</strong>-3606E Message Terminal.<br />
The hardware problem indication is three beeps repeated<br />
every 10 seconds. Below is a list of re<strong>as</strong>ons for the beeps.<br />
The specific re<strong>as</strong>on will be shown on the message terminal:<br />
• Hardware error in the distress button<br />
installation.<br />
• Position is not updated for an extended period.<br />
• No access to the satellite signal.<br />
The printer problem indication is two beeps repeated every<br />
10 seconds. Below is a list of re<strong>as</strong>ons for the beeps. The<br />
specific re<strong>as</strong>on will be shown on the message terminal:<br />
31