TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
TT-3000E mini-C GMDSS User Manual - Polaris-as.dk
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>TT</strong>-<strong>3000E</strong> <strong>mini</strong>-C <strong>GMDSS</strong> <strong>User</strong> <strong>Manual</strong><br />
4 THE DISTRESS ALERT INSTALLATION<br />
As explained in sections 3.3 the <strong>TT</strong>-<strong>3000E</strong> system is capable<br />
of sending maritime distress alerts using the AP5042 Alarm<br />
Panel [5]. For distress alerting this panel includes a distress<br />
button with a red light inside and a buzzer.<br />
4.1 SENDING DISTRESS<br />
In the normal operational state the alarm button light is off<br />
and the buzzer is silent.<br />
An alert is initiated simply by pressing the distress button<br />
for more than 5 seconds. During these 5 seconds the button<br />
light will fl<strong>as</strong>h and the buzzer will beep. After 5 seconds<br />
the red light goes steady on and the buzzer will be silent.<br />
The distress signal is now being sent.<br />
After a little while (typically around half a minute <strong>as</strong> a<br />
rough average) a confirmation is received by the transceiver<br />
and the red light will show this by being on with a short<br />
off-period every 15 seconds. If the alert is not delivered<br />
(e.g., due to bad satellite signal conditions) the button light<br />
will turn off.<br />
At any time it is possible to cancel a Distress Alert using<br />
“Abort transmission” from the Options menu. Be aware that<br />
a Distress Alert is usually sent within 10-30 seconds.<br />
To reset the button light to the normal off-state use the<br />
following procedure:<br />
1. Select “Clear distress indication” from the Distress<br />
menu on the <strong>TT</strong>-3606E Message Terminal.<br />
The system can be tried out in Distress Test mode where all<br />
indications work like in ‘normal’ operation but no alerts<br />
will be sent (the system will behave like the alert is<br />
30