Punching Information - Alfra

A
ALFRA – Machine for processing of laminated busbars
Made in Germany by ALFRA
For punching M6 – M14 (without insulation) and cutting flexible laminated
rails
Thickness up to 10 mm (without insulation)
Width up to 100 mm (without insulation)
Application area:
n Separation and punching holes on finned Cu and Al rails
n Separation thickness: max. 10 mm
n Hole area: Through holes for M6 – M14 screws
n Dimension H x W x D: 400 x 250 x 150 mm (without Length stop)
n Weight: 32 kg
Main machine
n Serves for holding: Cutting block and hole punching tools
n The pressure unit comprising hydraulic piston and cylinder including
punch holder in the top part are permanently integrated in the main
unit.
n The centric holder hole for dies and cutting block insert are located in
the lower part. Foldable stops in front and on the sides for punching
are additionally mounted in the machine .
Prod.-No.
Basic unit for laminated rails, with length and side stops,
Cylinder and quick coupling 03300
Cutting block 03301
Accessories:
Punch with neoprene and pressure plates:
Ø 5,0 mm 03303
Ø 6,0 mm 03304
Ø 9,0 mm 03305
Ø 11,0 mm 03306
Ø 14,0 mm 03307
Dies:
Ø 5,0 mm 03308
Ø 6,0 mm 03309
Ø 9,0 mm 03310
Ø 11,0 mm 03311
Ø 14,0 mm 03312
Other Ø upon request.
Prod.-No. 02121
Prod.-No. 02027
Prod.-No. 03853
As drive we recommend our foot pump Prod.-No. 02121 or our electro-
hydraulic pump DSP 120 Prod.-No. 02027 or AHP 03-1 Prod.-No. 03853.
Inch sizes are available on request
Prod.-No. 03300 basic unit
Prod.-No. 03301 cutting block
with length stop. Can easily be
inserted in the basic unit.
A/53