cessna-172-training-supplement

47. Are the power settings listed on the landing profiles exact or
approximate?
48. Is the aiming point also the touchdown point? If not, what is the
difference?
49. What is the maximum recommended flap setting for crosswinds?
50. Does ATP recommend the crab method or wing-low sideslip method
during a crosswind approach and landing?
51. When using the wing-low sideslip technique, will left or right rudder be
required during a strong right crosswind?
52. Which control surface, aileron or rudder, corrects for wind drift during a
crosswind landing?
53. During crosswind landings, which control surface, aileron or rudder
longitudinally aligns the airplane with the runway centerline?
54. What is the max demonstrated crosswind in the 172?
55. When flying the downwind leg with a strong tailwind, where should
the turn to base be started?
• At the 45˚ angle to the intended touchdown point
• Before reaching the 45° point
• After reaching the 45° point
56. What control inputs, if any, should the pilot apply after the airplane
touches down?
57. What is the difference between a go-around/missed approach and a
rejected landing?
58. How do you determine a standard-rate turn on an aircraft with a G1000
system?
59. In the event of an AHRS failure, which indications will no longer be
displayed on the PFD? Which indications will still be visible on the PFD?
60. Which instrument approaches are available with the PFD inoperative?
An AHRS failure?
61. How does the aircraft provide basic flight instrument information in the
event of a total electrical failure?
74 • Oral Review