uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1. Setting Up for DAMA<br />
Appendix G<br />
AN/WSC-3<br />
At antenna controller, dial in the elevation and azimuth of satellite (such as, <strong>UHF</strong><br />
follow-on 6) that the assigned channel is located. This setting depends on a ship’s<br />
location and it changes as the ship travels the ocean. There is an azimuth/elevation<br />
<strong>com</strong>putation aid used to determine these values; each ship has one or more.<br />
a. Verify all power to the SA-2000 is on and all switches are turned on.<br />
b. On WSC-3 turn on or set as follows:<br />
(1) Turn power on.<br />
(2) Place standby/operate switch to operate.<br />
(3) Place control switch to local.<br />
(4) Place SATCOM/LOS switch to SATCOM.<br />
(5) Place modulation switch to EXT Modem.<br />
(6) For frequency select switches, dial the uplink frequency from Daily Comm<br />
Status message for the operational channel (for example, CONUS DAMA 1).<br />
(7) Completely turn power control knob clockwise, then turn back approximately<br />
one-quarter turn.<br />
(8) Partially extend radio from chassis.<br />
(a) Set SATCOM offset switch to offset 4. (This is the normal setting if the<br />
difference between uplink and downlink frequency is 41-MHz. Sometimes offset 3 is<br />
used if the difference is 33.6-MHz.)<br />
(b) This switch sets the downlink frequency in the radio.<br />
(c) Set TDMA/non-TDMA switch to TDMA position.<br />
(d) Return radio into chassis.<br />
c. At SB-4125 or SB-4126 IF patch panel, patch the TD-1271 Xmt to the<br />
transmitting radio. Patch the TD-1271 Rcv to the receiving radio. (Usually it is the<br />
same radio.)<br />
d. On the SB-4124 PATCH panel on the OK-454 or OK-455 equipment rack, ensure<br />
the TD-1271 XMT position is either normal thru’d or patched to the radio used to<br />
transmit. This TD-1271 XMT position is the top left position on the panel (A1J1).<br />
e. At the TD-1271.<br />
(1) Turn on the TD-1271.<br />
(2) Ensure the transmit inhibit switch is off.<br />
G-1