uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
STEP 12. If additional keys need to be filled, select desired key on fill device (if<br />
applicable) and repeat steps 6 through 9. If key fill operation is <strong>com</strong>plete, turn off and<br />
disconnect COMSEC fill device from fill panel. Rotate mode select from F1 to CT or PT<br />
position.<br />
Note: If at any time, the radio displays an alarm condition; follow the instruction<br />
given by the radio to clear the alarm properly.<br />
If an alarm condition does not clear using the instructions given, press<br />
the ↑ X/E switch to escape the menu and reset the radio.<br />
If an alarm condition persists, turn off radio for 15 to 30 seconds and then<br />
turn the radio on in PT mode. Allow the radio to go through BIT to<br />
ensure fault is not a system failure. Once BIT is <strong>com</strong>plete and the radio<br />
goes into the current operations mode, continue previous operation.<br />
6. Download Presets<br />
Note: Unless stated otherwise, all switches and controls called out in this<br />
procedure are on the control indicator (CI).<br />
STEP 1. Set mode switch on fill panel to PT. After BIT is <strong>com</strong>plete, the display<br />
shows the last active operational CURRENT MODE.<br />
LOS-P01 Rx-PT-120<br />
AM V16K<br />
R378.050 T378.050<br />
GUARD: OFF<br />
S/G M/Z D/D P/N X/E<br />
STEP 2. Press MODE (M/Z)↑. The display shows the CI mode menu.<br />
STEP 3. Insert the pre-loaded PCMCIA card into PCMCIA port on the CI.<br />
STEP 4. Rotate selector control knob to select LOAD PRESETS and press ENTER<br />
(ENT) ↓.<br />
CI MENU<br />
CMD: SAVE PRESETS<br />
ENT<br />
STEP 5. The display shows the LOAD PRESETS submenu. Notice toggle switches<br />
on CI change function and are re-identified.<br />
STEP 6. Press LOAD switch up or down to activate loading process.<br />
F-3