uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com

More documents

Recommendations

Info

Appendix E LST-5D Radios 1. LST-5D LOS Procedures (Updated: 02 APR 98) a. Reminder. (1) HD SET—Use a 6-pin audio connector plain text handset connector only. (2) LOS—Refers to line of sight. The radio is configured in the AM mode. This may be used for ground-to-air and air-to-ground communications. If FM is required in a LOS environment, the radio is configured in the SATCOM mode. (3) Audio/Data/Fill Connector—Connects to handset in secure voice modes, data devices in secure data modes, or fill devices in fill modes. b. Prior to COLD START, press 0 and right arrow together. Then turn on the radio. This will MASTER CLEAR all settings and crypto in the radio, if needed. c. Cold start initialization. Note: The down arrow button works as the “enter” button. (1) When unit is powered up in an un-initialized state, the unit performs system tests and then displays a blinking ALARM message. (If the alarm blinks without going to self-test, press ESC twice and then self-test begins.) The speaker shaped icon in the lower left corner of the display is an ALARM annunciator. As long as the internal COMSEC KG is not initialized, the radio set remains in the ALARM condition and displays the ALARM message. (2) Rotate the key management (KGMT)switch to the LD KG position, then depress and release the ESC on the front panel keypad twice. The SELF TESTING message is displayed after the internal COMSEC KG successfully performs its power up tests. (3) Once the radio completes and passes all power up tests (approximately 60 to 70 seconds) the radio displays a prompt to connect a fill device. (4) The radio is not used in a secure mode, move the KGMT switch to operate (OP) position. (5) The three-digit alarm code in the lower right corner of the display should read 050. (6) The three digit error code 255 is a catchall error code. Reinitiate the radio. E-1
E-2 d. Programming operating modes. Note: The left and right arrow buttons move to the menu option needed. (1) Turn the mode select to OP position. (2) At the function screen, usethe right arrow button to select PROG and then depress the down arrow button. (3) The program menu displays MODES and FREQS. (4) Select FREQS depress the right arrow button followed by the down arrow button to enter. (5) The Program Freqs Menu displays CH1 with the RX—TX (DOWNLINK/UPLINK) UHF frequencies. Insert the appropriate frequencies in the channels (there are nine channels to use). (6) Depress the up arrow until STORE FREQ menu is displayed. Select YES and depress the down arrow button to enter and save. (7) At the program screen, select MODES using the left arrow button followed by the down arrow button to enter. (8) Select the preset to store the configuration into (enter a number) and depress the down arrow button. (9) Scroll through the terminal selections and select LOS, depress the down arrow button. (10) Display/SOURCE KG, select PT, depress the down arrow button. (11) Display/RADIO SCAN, select OFF, depress the down arrow button. (12) Display/CHANNEL SELECT, select the preset channel, depress the down arrow button. (13) Display/POWER ADJ, select LOW or HIGH, depress the down arrow button. (14) Select SAVE, depress the down arrow button to store. (15) Display/STORE INTO PRESET (what ever the circuit preset is 1 to 6) (16) Press ESC until the OP screen is displayed and select OP. (17) Recall the PRESET.
Page 1 and 2:
UHF TACSAT /DAMA MULTI-SERVICE TACT
Page 3 and 4:
1. Scope PREFACE The intent of this
Page 5 and 6:
c. We encourage recommended changes
Page 7 and 8:
Acquire Resources .................
Page 9 and 10:
TABLES Figure III-5. AN/WSC-3 .....
Page 11 and 12:
EXECUTIVE SUMMARY UHF TACSAT/DAMA M
Page 13 and 14:
1. Introduction Chapter I Overview/
Page 15 and 16:
Figure I-1. UHF SATCOM Functional O
Page 17 and 18:
elationship is not clearly defined.
Page 19 and 20:
. Use a logical process for communi
Page 21 and 22:
communications planner determines w
Page 23 and 24:
Figure I-4. Long-Range (50 to 150 k
Page 25 and 26:
I-13 Figure I-6. Military UHF Satel
Page 27 and 28:
(a) A shared time-slot dedicated to
Page 29 and 30:
sent at that time and the number of
Page 31 and 32:
Figure I-10. A Segment Slots I-19
Page 33 and 34:
Figure I-12. C Segment Slots e. The
Page 35 and 36:
i. For TDMA DAMA, the time-slots wi
Page 37 and 38:
Figure I-16. Communications on 25-k
Page 39 and 40:
. Voice. (1) Bandwidth (25-kHz or 5
Page 41 and 42:
This reduces the number of time-slo
Page 43 and 44:
Radio Item AN/PRC-117F III-2 Table
Page 45 and 46:
III-4 d. AN/ARC-231. (See Appendix
Page 47 and 48:
III-6 i. USC-42(V)1, 2, 3 (mini-DAM
Page 49 and 50:
III-8 Table III-2. OW Key Positions
Page 51 and 52:
. User requirements— (1) Azimuth
Page 53 and 54:
(6) Logging out. (a) For 5-kHz DAMA
Page 55 and 56:
Spectrum Manager MARFORLANT; MARFOR
Page 57 and 58:
Appendix A SATELLITE CHANNEL AUTHOR
Page 59 and 60:
Table A-1. Satellite Channel (Home
Page 61 and 62:
Table A-1. Satellite Channel (Home
Page 63 and 64:
Appendix B Information Request Code
Page 65 and 66:
Table B-1. Information Request Code
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Table B-2. Configuration Codes Conf
Page 73 and 74:
C-2 Option Table C-2. MIL-STD 188-1
Page 75 and 76:
C-4 Table C-4. UHF SATCOM Programmi
Page 77 and 78:
pointing using the SATCOM receive s
Page 79 and 80:
5. AN/PSC-117F DAMA UHF SATCOM a. U
Page 81 and 82: C-10 Table C-7. DAMA Programming Ch
Page 83 and 84: C-12 Table C-8. DAMA Net Preset Par
Page 85 and 86: C-14 Figure C-6. DAMA Port Configur
Page 87 and 88: C-16 Figure C-7. DAMA Destination P
Page 89 and 90: h. Passive ranging and ephemeris da
Page 91 and 92: (c) Select the destination to be ca
Page 93 and 94: • ACTIVE—Service request has be
Page 95 and 96: q. Terminate 25-kHz AC DAMA calls o
Page 97 and 98: communications. Slower data rate li
Page 99 and 100: (d) Select the desired DAMA net by
Page 101 and 102: completion of the communications. P
Page 103 and 104: C-32 Figure C-12. MSG Service Call
Page 105 and 106: C-34 Figure C-14. DAMA Service Stat
Page 107 and 108: 1. Line of Sight (LOS) Operations A
Page 109 and 110: k. Enter channel number (009 to 239
Page 111 and 112: GUARD LIST VIEW 1 64000 ------ ----
Page 113 and 114: (13) For DASA only, enter time requ
Page 115 and 116: Message Action A Acquisition Failed
Page 117 and 118: Message Action Aborted To:xxxx (Rea
Page 119 and 120: Table D-7. Hot Keys, 5-kHz DAMA Key
Page 121 and 122: (9) Enter configuration code, if re
Page 123 and 124: (1) Select over-the-air, if the ter
Page 125 and 126: 25-kHz AD HOC DAMA SETUP GUIDE - AN
Page 127 and 128: 5C/D RADIOS 1. The following are re
Page 129 and 130: Table D-8. 5-kHz DAMA Operations (S
Page 131: Table D-8. 5-kHz DAMA Operations (S
Page 135 and 136: (12) After pushing the variable pos
Page 137 and 138: d. radio. Prior to COLD START, pres
Page 139 and 140: aa. INTKG should flash. Leave as is
Page 141 and 142: 1. Skyfire Operator Training Append
Page 143 and 144: The following message appears- F-2
Page 145 and 146: F-4 CI MENU LOAD PRESETS LOADING PR
Page 147 and 148: STEP 2. Rotate selector control kno
Page 149 and 150: (1) On = Activates guard receiver.
Page 151 and 152: 1. Setting Up for DAMA Appendix G A
Page 153 and 154: (1) Enter *92 then depress the Ente
Page 155 and 156: Appendix H EMI CHARACTERIZATION CHE
Page 157 and 158: Appendix J CUT SHEETS The following
Page 159 and 160: DAMA Database Set up Presets Mode P
Page 161 and 162: Appendix K Prioritization Scheme Ta
Page 163 and 164: References Joint CJCSM 3122.01, Joi
Page 165 and 166: COCOM combatant command COMM commer
Page 167 and 168: IO Indian Ocean IP internet protoco
Page 169 and 170: P PAC Pacific PCC primary channel c
Page 171 and 172: USARPAC United States Army, Pacific
Page 173 and 174: attitude can be measured by the ang
Page 175 and 176: channel control orderwire channel c
Page 177 and 178: participate in a class broadcast fr
Page 179 and 180: data stream into burst-formatted da
Page 181 and 182: low power satellite A satellite wit
Page 183 and 184:
preamble Consists of a carrier segm
Page 185 and 186:
permit them to escape from the Sun
Page 187 and 188:
waveform The combination of baseban
Page 189 and 190:
COMSEC custodians, III-7 connection
Page 191 and 192:
DAMA, I-7, III-6, C-20 point-to-poi
Page 193 and 194:
data, I-24 data rate, I-24 disadvan
Page 195:
MARINE CORPS: PCN 144 00003 80 PIN:
show all

uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?