uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
(1) Select over-the-air, if the terminal is off for 30 minutes or longer. Select force<br />
locally, if less than 30 minutes.<br />
LOGOUT<br />
Over The Air<br />
(2) Press ENT on SEND.<br />
{SEND}<br />
Note: A status message confirms the result of the log out. If no log out was sent, or<br />
if the terminal was off for more than 30 minutes after a force locally log out,<br />
the JMINI logs the terminal out of the network.<br />
MESSAGE<br />
Input Rejected Transmission rejected. Another operator is transmitting - try again later. Or, radio is in idle – set up a <strong>service</strong>.<br />
Output Rejected Transmission rejected. Another operator is transmitting - try again later. Or, radio is in idle – set up a <strong>service</strong>.<br />
Setup Rejected,<br />
(Reason)<br />
Terminated<br />
Frm:xxxx to:yyyy<br />
(Reason)<br />
Mode Command<br />
Rejected, Node<br />
Address is Zero<br />
Msg Setup Rejected<br />
Precedence<br />
Violation<br />
No Resources for<br />
Message From:xxxx<br />
R RANGING<br />
Message setup is rejected for the stated reason.<br />
Message is terminated for the stated reason. Try again later.<br />
Terminal address is entered as zero. This is reserved for the controller. Enter a valid terminal address.<br />
Precedence entered is not allowed. Check network state menu for allowed values and re-enter.<br />
Terminal is busy and cannot receive a message from the other terminal.<br />
Failed Check current mode entries and antenna. Run BIT to verify terminal operation.<br />
Overdue Transmit<br />
Inhibited<br />
S SERVICE SETUP<br />
A successful ranging attempt has not been <strong>com</strong>pleted as scheduled. Transmission is denied. Check antenna.<br />
Transmit a ranging burst using the contention ranging menu.<br />
Command Rejected Verify connected and logged in and try again.<br />
T<br />
Rejected, Invalid<br />
Data Rate<br />
Teardown Command<br />
Rejected<br />
Transmission<br />
Rejected Re-<br />
Transmit<br />
Tx Rejected, Check<br />
Mode & Status Msgs<br />
Retransmit<br />
Ensure a valid data rate is selected.<br />
The terminal has rejected the teardown request. Verify Idle.<br />
Transmission rejected. Another operator is transmitting - try again later. Or, radio is in idle – set up a <strong>service</strong>.<br />
Transmission rejected. Another operator is transmitting - try again later. Or, radio is in idle – set up a <strong>service</strong>.<br />
D-17