uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Message Action<br />
Aborted To:xxxx<br />
(Reason)<br />
From: xxxx Encrypt<br />
Mismatch Detected<br />
Input Rejected<br />
Output Rejected<br />
Table D-4. Messages, 5-kHz DAMA<br />
Message is aborted for the stated reason. Try again.<br />
Mode switch (PT/CT) setting is different from the transmitting terminal.<br />
Contact distant end to correct.<br />
Transmission rejected. Another operator is transmitting—try again later.<br />
Or<br />
Radio is in idle—set up a <strong>service</strong>.<br />
Transmission rejected. Another operator is transmitting—try again later.<br />
Or<br />
Radio is in idle—set up a <strong>service</strong>.<br />
Set up Rejected,<br />
(Reason)<br />
Message set up is rejected for the stated reason.<br />
Terminated Frm: xxxx<br />
to:yyyy (Reason)<br />
Message is terminated for the stated reason. Try again later.<br />
Mode Command<br />
Rejected, Node<br />
Address is Zero<br />
Terminal address is entered as zero. This is reserved for the controller.<br />
Enter a valid terminal address.<br />
Msg Set up Rejected Precedence entered is not allowed. Check network state menu for allowed<br />
Precedence Violation values and re-enter.<br />
No Resources for<br />
Message From: xxxx<br />
Terminal is busy and cannot receive a message from the other terminal.<br />
R RANGING<br />
Failed<br />
Check current mode entries and antenna. Run BIT to verify terminal<br />
operation.<br />
Overdue Transmit<br />
Inhibited<br />
A successful ranging attempt is not <strong>com</strong>pleted as scheduled. Transmission<br />
is denied. Check antenna. Transmit a ranging burst using the contention<br />
ranging menu.<br />
S SERVICE SET UP<br />
Command Rejected Verify connected and logged in and try again.<br />
Rejected, Invalid Data<br />
Rate<br />
T<br />
Ensure a valid data rate is selected.<br />
Teardown Command<br />
Rejected<br />
The terminal has rejected the teardown request. Verify Idle.<br />
Transmission<br />
Rejected Re-Transmit<br />
Transmission rejected. Another operator is transmitting—try again later.<br />
Or<br />
Radio is in idle—set up a <strong>service</strong>.<br />
Tx Rejected, Check Transmission rejected. Another operator is transmitting—try again later.<br />
Mode & Status Msgs Or<br />
Retransmit Radio is in idle —set up a <strong>service</strong>.<br />
D-11