uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
uhf tacsat /dama multi-service tactics, techniques ... - UHF-Satcom.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>com</strong>pletion of the <strong>com</strong>munications. Perform the following procedure for <strong>service</strong><br />
teardown:<br />
(1) At end of using a DAMA <strong>service</strong>, press CALL key on KDU.<br />
(2) Use up/down arrow keys to scroll to TEARDOWN. Press ENT to begin<br />
teardown.<br />
(3) Use the up/down arrow keys to select the desired <strong>service</strong> to teardown. Press<br />
the circular arrow keys to view the second screen of the <strong>service</strong> state.<br />
(4) Press ENT to teardown this <strong>service</strong>.<br />
cc. Terminate call (5-kHz dedicated call only). If time is remaining, dedicated calls<br />
should be terminated. Perform the following procedure to terminate a dedicated call:<br />
(1) At the end of using DASA dedicated <strong>service</strong>, press CALL button on KDU.<br />
(2) Use up/down arrow keys to scroll to TERMINATE CALL.<br />
(3) Press ENT to terminate call.<br />
(4) Service state goes to IDLE after reacquiring the network home channel.<br />
dd. Send a message using 5-kHz DAMA message <strong>service</strong>. DATA messages of less<br />
than 14 kilobytes are uploaded to radio and the packet is sent to the destination<br />
address. The terminal prompts a message upload to the radio. Perform the following<br />
procedure to send a message:<br />
(1) Ensure the DATA device is connected to the J1 ADF connector or J3 data<br />
connector and is ready for operation with a message to be transmitted.<br />
(2) Select a DAMA port configuration preset that properly interfaces the data<br />
device to the radio using KG-84C encryption.<br />
(3) Press the circular arrow keys to move display screens to <strong>service</strong> state screen<br />
to place radio in MSG mode. If radio is in CKT mode, use the left/right arrow keys to<br />
scroll to MODE and change to MSG mode with the up/down arrow keys, then press<br />
ENT.<br />
(4) Press CALL key to bring up display for SELECT REQUEST TYPE. See<br />
Figure C-12.<br />
(5) Select SEND A MESSAGE and press ENT.<br />
(6) Select DAMA destination preset to which the message is sent and press ENT.<br />
TBAs associated with this preset are shown across the bottom line of the display.<br />
(7) The next display is SELECT PRECEDENCE. The display shows the<br />
precedence last used to call the selected destination. Press ENT to keep that precedence,<br />
or scroll and select an alternate message precedence.<br />
(8) After a brief configuring screen, the terminal prompts the user to ENTER<br />
MESSAGE to the radio. Send the message on the data device to upload it into the<br />
radio. Press CLR to abort.<br />
(9) When uploading is <strong>com</strong>plete, the <strong>service</strong> state indicates IDLE with a message<br />
status of one (1) for outgoing. After the message is transmitted, the outgoing message<br />
indicator number decreases.<br />
C-30