24.12.2012 Views

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Installing Windows 2000 Advanced Server (ES5044R, ES5085R, <strong>and</strong> ES2024R)<br />

ù This is the only server in my network.<br />

ù One or more servers are already running in my network.<br />

ù I will configure this server later.<br />

13. Click “I will configure this server later.” Then click Next.<br />

14. Tab to the check box labeled “Show this screen at startup” <strong>and</strong> clear it.<br />

15. Close the Configure Your Server window.<br />

At this point, you should still be logged on as the administrator. Complete Windows 2000<br />

Advanced installation as described in 7.2.<br />

3.3. Configuring the RAID Controller<br />

Configure the RAID disk controller for RAID level 1 (mirroring) for two disks units.<br />

Sites can reconfigure a different RAID level following hardware RFU, if desired. For<br />

detailed information see the Mylex RAID Management documentation available on the CD-<br />

ROM labeled "Mylex Solutions Software Kit x.xx."<br />

Notes:<br />

• Switch the monitor concentrator to the Intel node position before beginning (see<br />

2.5.2).<br />

• If you are performing a full installation on a system that was preloaded, do not<br />

format the RAID disk. Instead, use the DAC BIOS utility to initialize the RAID<br />

volume before you reload the operating system. Formatting the disk makes the drive<br />

unrecognizable to the software.<br />

• In step 2, you must press Alt-M within a few seconds to enter the BIO Options<br />

Utility.<br />

• In step 8, you must press Alt-R within a few seconds to enter the RAID controller<br />

configuration procedure; otherwise, the normal boot procedure continues. See next<br />

note for ES2024R server.<br />

• For the ES2024R server, before you press Alt-R, you must press Alt-M to access the<br />

BIOS options utility. Then press Alt-R in order to access the Mylex RAID EzAssist<br />

utility, as instructed in step 8.<br />

Take the following steps to run the RAID controller configuration utility:<br />

1. Power on or reboot the Intel node.<br />

Several start-up messages appear, ending in a prompt to press Alt-M, as follows:<br />

DAC1100 ADAPTER BIOS VERSION x.xx<br />

Mylex Corporation<br />

Host Adapter-1 Firmware Version x.xx DRAM size xxx MB<br />

.<br />

.<br />

.<br />

Spinning up drives...<br />

.<br />

7850 5104–009 Version 009B (Web Only) 3–13

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!