24.12.2012 Views

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Installing Windows 2000 Advanced Server (ES5044R, ES5085R, <strong>and</strong> ES2024R)<br />

ES2024R server:<br />

A screen appears with a set of networking components for the first network device<br />

detected, the SysKonnect FDDI PCI Adapter SK-5544. These default components are<br />

checked:<br />

• Client for Microsoft Networks<br />

• File <strong>and</strong> Print Sharing for Microsoft Networks<br />

• Network Monitor Driver<br />

• Internet Protocol (TCP/IP)<br />

You may change these selections as desired. Click components to check or uncheck<br />

them. Then proceed as follows:<br />

a. Click Internet Protocol (TCP/IP) to highlight it, then click Properties.<br />

b. Click “Use the following IP address.”<br />

Note: You must know if this Windows 2000 or NT server node is being<br />

installed as the first, second, third, or fourth Windows node in the<br />

<strong>ClearPath</strong> <strong>IX</strong> system to which it is connected. You will use the IP<br />

address associated with that node number. The addresses are listed in<br />

Table B-1.<br />

c. In the IP Address field, type the appropriate FDDI address for this node (for<br />

example, 192.168.057.003 for the first Intel node) as described in Appendix B,<br />

Table B–1. Then press Tab.<br />

d. In the Subnet Mask field, enter the address 255.255.255.0.<br />

e. Click the Advanced button.<br />

f. Click the Add button in the IP Addresses box.<br />

g. Enter the other two addresses <strong>and</strong> subnet masks from Table B–1. Then click OK.<br />

h. Click OK.<br />

i. Click Next.<br />

A screen appears with the next configurable device: the IBM Netfinity Fault<br />

Tolerance PCI Adapter. The following default components are checked:<br />

• Client for Microsoft Networks<br />

• File <strong>and</strong> Print Sharing for Microsoft Networks<br />

• Internet Protocol (TCP/IP)<br />

Continue by configuring the Netfinity card:<br />

j. Click Internet Protocol (TCP/IP) to highlight it, then click Properties.<br />

k. Click “Use the following IP address.”<br />

l. In the IP Address field, enter the IP address for the Windows 2000 Advanced node<br />

from Table 2–2, then press Tab.<br />

m. Change the subnet mask to the netmask address from Table 2–2, or skip this field<br />

(accept the default).<br />

7850 5104–009 Version 009B (Web Only) 3–11

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!