ClearPath IX Systems Installation and Configuration Guide

Installing Windows 2000 Advanced Server (ES5044R, ES5085R, and ES2024R)
A Licensing Modes screen appears.
5. Click the per-seat licensing option, then click Next to proceed.
The Computer Name and Administrator Password screen appears.
Note: The computer name (up to 15 characters) is the Network Basic
Input/Output System (NETBIOS) name that uniquely identifies the
computer in the Windows 2000 Advanced workgroup or domain. It must be
different from the workgroup or domain name.
6. In the name field, enter the host name from Table 2–2 by which the Windows 2000
node will be identified on the external TCP/IP network. Tab to the administrator
password.
a. In the password field, type administrator.
b. Tab to Confirm Password. Type administrator in that field.
c. Click Next to proceed.
Note: Following installation, the site must change the default password
(administrator) to a different password.
A tabbed Date and Time Settings screen appears. If you do not need to set the date
and time, click Next, then skip to step 8. Otherwise continue with step 7.
7. Click the Date, Time, and Time Zone tabs (in any order) for the changes you need to
make. All are optional. Set the fields as follows:
• Month—Click the arrow keys and select the correct month on the calendar.
• Day of the month—Click the correct date to set it on the calendar.
• Time—Click the scroll bar arrow and scroll up or down until the correct time
appears.
• Time zone—To change the time zone, click the scroll bar arrow and scroll up or
down to select the correct time zone. The map shifts over the time zone selected.
• Daylight saving time—Click the check box to select daylight saving time if it
applies to the time zone.
Click Next when done with both the date and time.
After a minute or two, the Windows 2000 Server Setup screen indicates that Setup is
installing the networking settings.
About a minute later, a Windows 2000 Advanced Setup screen for configuring
networking appears.
8. A Networking Settings screen appears with the following check boxes:
• Typical settings
• Custom settings
9. Select Custom settings, then click Next.
Continue customization by following the instructions in the appropriate server
subsection below.
7850 5104–009 Version 009B (Web Only) 3–7