ClearPath IX Systems Installation and Configuration Guide

Installing Windows 2000 Advanced Server (ES5044R, ES5085R, and ES2024R)
3. Log on to Windows 2000 Advanced (3.5).
4. Complete the installation (Section 7).
3.2. Steps to Take If Windows 2000 Advanced Is
Preloaded
Following the screen that indicates Windows is preloaded (3.1, step 11), a second Windows
2000 server-setup screen appears.
Note: If you decide to perform a full installation even though the system is preloaded,
do not format the RAID disk. Instead, use the DAC BIOS utility to initialize the
RAID volume before you reload the operating system. Formatting the disk
makes the drive unrecognizable to the software.
1. Click Next to continue.
A Software License Agreement screen appears.
2. Have the client, or a representative of the client, accept the license agreement as
follows:
a. Read the contents of the first page, then press the Page Down key to read the next
page.
b. When you have read the entire agreement, click “I accept this agreement.”
c. Click Next.
After a few seconds a Windows 2000 Regional Settings screen appears.
d. If the settings are acceptable, click Next to proceed. Otherwise, modify the
settings as needed, then click Next.
The Windows 2000 Personalize Your Software screen appears, followed by a Name and
Organization screen.
3. Enter name and organization as follows:
a. Name field—Enter the user name the site wants identified with the Windows 2000
Advanced node.
b. Press the Tab key to advance to the Organization field.
c. Organization field—Enter the organization the site wants identified with the
Windows 2000 Advanced node.
d. Click Next to proceed to the next screen.
A Registration screen appears asking for the registration number from the Certificate
of Authentication.
4. Enter the registration number as recorded in Table 2–2, or enter it directly from the
Certificate of Authentication, as follows:
a. Type the required digits in each field.
b. Click Next to proceed.
3–6 Version 009B (Web Only) 7850 5104–009