24.12.2012 Views

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

<strong>Installation</strong> Checklists <strong>and</strong> Tips<br />

Recovering from a PING Test Failure<br />

The most common reason for PING test failure when you test interconnect communications<br />

(Section 14) is lack of an FDDI driver, or an incorrectly installed one, on the Intel<br />

node. Refer to the full operating system software installation procedure, or the Windows<br />

2000, Windows NT, or UnixWare documentation, for steps to correctly install <strong>and</strong><br />

configure the FDDI driver.<br />

2.3.2. Software Tips<br />

These are points to be aware of as you install <strong>and</strong> configure the software. More<br />

information follows in this section.<br />

• Creating emergency recovery diskettes<br />

• Choosing to perform a full installation even when software is preloaded or preinstalled<br />

• Finding the correct license information for SCO UnixWare <strong>and</strong> Enterprise Backup <strong>and</strong><br />

Restore<br />

• Configuring OS 2200 print queues<br />

• Deciding to install Windows NT Server as a primary or backup domain controller<br />

• Changing SPO aliases<br />

• Configuring CMS 1100<br />

• Changing the installation passwords following hardware RFU<br />

• Modifying Windows NT/2000 server network settings after installation<br />

Creating Emergency Recovery Diskettes<br />

You must create an emergency recovery diskette for each Windows 2000 node, each<br />

Windows NT node, each UnixWare node, <strong>and</strong> the SPO server. The procedures for creating<br />

those diskettes are described as part of the procedures for completing installation of<br />

Windows NT (7.1.17), Windows 2000 (7.2.9), <strong>and</strong> UnixWare (8.13).<br />

Performing a Full <strong>Installation</strong> When Software Is Preloaded or Preinstalled<br />

Intel node <strong>and</strong> system console software are preloaded on servers shipped to U.S. sites.<br />

SPO server software, in addition to being preloaded, is preinstalled. Because a full set of<br />

installation media is provided, you may wish to perform the full installation procedure,<br />

even with software preloaded or preinstalled, for the following reasons:<br />

• A problem was encountered while performing the procedure for preloaded or<br />

preinstalled software.<br />

• The site wants to verify that the installation media are good for future use.<br />

• The site wants to train people in installation <strong>and</strong> configuration procedures for a<br />

particular node.<br />

• Some other reason particular to the site or to the system being installed.<br />

2–8 Version 009B (Web Only) 7850 5104–009

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!