ClearPath IX Systems Installation and Configuration Guide

More documents

Recommendations

Info

Introduction and Installation Overview OS 2200 Node 2200 System Application External Communications Interface Private Interconnect External Communications Interface Intel Node Client Application Intel Node Operating System Intel Node Client Application Intel Node Operating System Figure 1–3. Single OS 2200 Node with Multiple Intel Nodes (Up to Four) 1–10 Version 009B (Web Only) 7850 5104–009
External Communications Interface OS 2200 Node 1 2200 System Application 1 OS 2200 Node 2 2200 System Application 2 Partitioned 2200 System Introduction and Installation Overview Private Interconnect External Communications Interface Intel Node Client Application Intel Node Operating System Intel Node Client Application Intel Node Operating System Figure 1–4. Multiple OS 2200 Nodes with Multiple Intel Nodes Follow these steps when installing a ClearPath IX server with multiple nodes: 1. Ensure that the factory-built customer ODB files are configured to support planned OS 2200 node HMP configurations (Appendix D). 2. Install the ClearPath IX server 2200 node, boot and run SUMMIT, and run the applicable FDDI LAN test as summarized in the CSR overview (1.2). 3. Install the operating system IOE on the first Intel node according to the instructions in the applicable operating system IOE section. During installation of the operating system or later (such as when running a tuning script in the case of UnixWare), configure the following networking information: a. The hostname and IP address that identify the node on the private interconnect (see Appendix B). b. The hostname and IP address that identify the node on the external Ethernet (TCP/IP) network at the site (see 2.2). c. The same hostnames and IP addresses as configured for the operating system must be configured for network interface cards (both FDDI and Ethernet) for the node. 4. Repeat step 3 for each subsequent Intel node until the operating system IOE has been installed on each Intel node. 7850 5104–009 Version 009B (Web Only) 1–11
Page 1 and 2: Unisys e-@ction ClearPath Enterpris
Page 7 and 8: Contents About This Guide .........
Page 9 and 10: Contents 4.4. Installing and Config
Page 11 and 12: Contents 8.4. Installing the UnixWa
Page 13 and 14: Contents 11.6. Configuring the FTP
Page 15 and 16: Contents 14.4. Installing DSPER ...
Page 17 and 18: Appendix D. Configuring the FDDI In
Page 19 and 20: Figures 1-1. ClearPath IX Server Co
Page 21 and 22: Tables 1-1. Operating System Levels
Page 23 and 24: Examples 14-1. A Minimum CMS 1100 C
Page 25 and 26: About This Guide Purpose Scope This
Page 27 and 28: How to Use This Guide About This Gu
Page 29 and 30: About This Guide Section 15. Instal
Page 31 and 32: About This Guide ClearPath HMP IX S
Page 33 and 34: About This Guide This guide gives c
Page 35 and 36: About This Guide OS 2200 Exec Syste
Page 37 and 38: Notation Conventions About This Gui
Page 39 and 40: Section 1 Introduction and Installa
Page 41 and 42: Table 1-2. ClearPath IX Server Comp
Page 43 and 44: 1.2.2. Installation Procedure Overv
Page 45 and 46: Introduction and Installation Overv
Page 47: • Configure a resilient 2200 node
Page 51 and 52: Section 2 Installation Checklists a
Page 53 and 54: Table 2-1. General Installation Inf
Page 55 and 56: Component Windows 2000 or Windows N
Page 57 and 58: 2.3. Installation Tips Caution Inst
Page 59 and 60: Finding Correct UnixWare and EBRS L
Page 61 and 62: 2.4.1. DEPCON Workstation Requireme
Page 63 and 64: Caution Installation Checklists and
Page 65 and 66: Installation Checklists and Tips 3.
Page 67 and 68: Section 3 Installing Windows 2000 A
Page 69 and 70: Installing Windows 2000 Advanced Se
Page 95 and 96: Section 4 Installing Windows NT Ser
Page 97 and 98: Installing Windows NT Server, Enter
Page 99 and 100:
Installing Windows NT Server, Enter
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Section 5 Installing Windows NT Ser
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
ID 0 1 2 3 4 5 6 Installing Windows
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Section 6 Installing Windows NT Ser
Page 151 and 152:
Installing Windows NT Server 4.0 (D
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
• Communications Installing Windo
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
6.5. Logging On As the Administrato
Page 173 and 174:
Section 7 Completing Windows Instal
Page 175 and 176:
7.1. Completing Windows NT Installa
Page 177 and 178:
Completing Windows Installation 14.
Page 179 and 180:
Completing Windows Installation To
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Completing Windows Installation Thi
Page 187 and 188:
SCSI 0, Bus 1, Id 5, Lun 0 ARCHIVE
Page 189 and 190:
Page 191 and 192:
7.1.16. Installing ess Software Com
Page 193 and 194:
Completing Windows Installation An
Page 195 and 196:
Completing Windows Installation Whe
Page 197 and 198:
Page 199 and 200:
Completing Windows Installation A s
Page 201 and 202:
Section 8 Installing UnixWare 7 Thi
Page 203 and 204:
Table 8-1. UnixWare 7 Installation
Page 205 and 206:
8.2. Steps to Take If Software Is P
Page 207 and 208:
8.3. Configuring the RAID Controlle
Page 209 and 210:
Installing UnixWare 7 7. Use the ar
Page 211 and 212:
Installing UnixWare 7 17. Change th
Page 213 and 214:
5. Kill Drive 6. Backup/Restore Con
Page 215 and 216:
Installing UnixWare 7 9. Select the
Page 217 and 218:
Installing UnixWare 7 6. Select the
Page 219 and 220:
Installing UnixWare 7 • Var File
Page 221 and 222:
Installing UnixWare 7 39. Press any
Page 223 and 224:
8.4.3. Installing the Drivers Updat
Page 225 and 226:
Installing UnixWare 7 12. Enter the
Page 227 and 228:
Installing UnixWare 7 3. Insert the
Page 229 and 230:
8.9. Retrieving and Applying Fixes
Page 231 and 232:
Installing UnixWare 7 Console outpu
Page 233 and 234:
Installing UnixWare 7 • Use the u
Page 235 and 236:
Section 9 Installing the ClearPath
Page 237 and 238:
Section 10 Installing SPO Basic Edi
Page 239 and 240:
Installing SPO Basic Edition and Re
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
2. At the password prompt, enter un
Page 267 and 268:
Section 11 Installing and Configuri
Page 269 and 270:
SPO Server SPO Basic Edition SPO Wo
Page 271 and 272:
Installing and Configuring SPO Work
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
• RPC configuration • Server
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
• Installing the SPO Basic Editio
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
Section 12 Configuring Intel Nodes
Page 309 and 310:
Configuring Intel Nodes for Monitor
Page 311 and 312:
Page 313 and 314:
Page 315 and 316:
Page 317 and 318:
Page 319 and 320:
Page 321 and 322:
Section 13 Installing the Basic OS
Page 323 and 324:
Installing the Basic OS 2200 IOE Yo
Page 325 and 326:
Installing the Basic OS 2200 IOE 5.
Page 327 and 328:
Installing the Basic OS 2200 IOE 2.
Page 329 and 330:
Installing the Basic OS 2200 IOE Yo
Page 331 and 332:
Section 14 Verifying the Interconne
Page 333 and 334:
14.2.1. Installing HLC-2 Microcode
Page 335 and 336:
Verifying the Interconnects and Ach
Page 337 and 338:
Page 339 and 340:
Page 341 and 342:
Page 343 and 344:
Page 345 and 346:
Page 347 and 348:
Section 15 Installing the Remaining
Page 349 and 350:
15.2.2. Setting Up the TIP Environm
Page 351 and 352:
APP 3 ROLLBACK INITIALIZATION START
Page 353 and 354:
INAP3 MAX PAGES Installing the Rema
Page 355 and 356:
Section 16 Customizing the Site Cus
Page 357 and 358:
Customizing the Site 1. Copy the ne
Page 359 and 360:
Customizing the Site 5. Verify your
Page 361 and 362:
Customizing the Site A dialogue box
Page 363 and 364:
Customizing the Site lan-address la
Page 365 and 366:
14. Select the Changes menu bar ite
Page 367 and 368:
Customizing the Site b. Select CP_U
Page 369 and 370:
Customizing the Site l. Repeat thes
Page 371 and 372:
16.6. Testing TCP/IP Communications
Page 373 and 374:
Customizing the Site ClearPath IX50
Page 375 and 376:
Section 17 Installing Optional OS 2
Page 377 and 378:
Appendix A Tables of Documentation,
Page 379 and 380:
Major Hardware or Software Changes
Page 381 and 382:
Major Hardware or Software Changes
Page 383 and 384:
Intel Platform Tables of Documentat
Page 385 and 386:
Tables of Documentation, Support, a
Page 387 and 388:
Appendix B Communication Settings S
Page 389 and 390:
Communication Settings Specific to
Page 391 and 392:
Appendix C SPO/HMP IX Interface Lic
Page 393 and 394:
SPO/HMP IX Interface License Key Re
Page 395 and 396:
Appendix D Configuring the FDDI Int
Page 397 and 398:
INVENTORY_INCLUDE: Limited Comprehe
Page 399 and 400:
The HLC-2 Subsystem Connections FDD
Page 401 and 402:
Appendix E Installing OPE and SysAd
Page 403 and 404:
Glossary A ACID properties The esse
Page 405 and 406:
Glossary central electronics comple
Page 407 and 408:
CSIOP D DAC daemon datagram See cha
Page 409 and 410:
DSA DSPER DTP DUA See directory ser
Page 411 and 412:
H HBA Abbreviation for host bus ada
Page 413 and 414:
Glossary Integration Expert The onl
Page 415 and 416:
Glossary master configuration table
Page 417 and 418:
N NAS NetBIOS See network access se
Page 419 and 420:
Glossary Open/OLTP Pathway An Open/
Page 421 and 422:
Glossary processing complex cabinet
Page 423 and 424:
Glossary SCO UnixWare A popular ver
Page 425 and 426:
Glossary Software Controlled Perfor
Page 427 and 428:
Glossary token ring A type of local
Page 429 and 430:
Glossary URM policy Parameters set
Page 431 and 432:
WWW X X.400 X.500 X/Open See World
Page 433 and 434:
Bibliography 2200 Series Single Poi
Page 435 and 436:
Bibliography OS 2200 Communications
Page 437 and 438:
Bibliography Unisys e-@ction Enterp
Page 439 and 440:
Index Numbered Entries 2200 node de
Page 441 and 442:
SysKonnect FDDI controller, 5-22, 8
Page 443 and 444:
planning, 2-2 private networks, pla
Page 445 and 446:
UnixWare 7, 8-4 procedures UnixWare
Page 447 and 448:
license information, 8-2 logon, 8-3
Page 450:
*78505104-009* 78505104- 009
show all

ClearPath IX Systems Installation and Configuration Guide

Create successful ePaper yourself

Delete template?

Save as template?