ClearPath IX Systems Installation and Configuration Guide

Introduction and Installation Overview
Install the central electronics
complex
Install the FDDI connections
for the internal LAN and connect
site administraton LANs
Install SCF workstation software
(if not preinstalled)
Power on 2200 Node
and run
diagnostic tests
Install and configure
Windows NT or UnixWare
software on each Intel node
(if not preinstalled)
Does site
already have
SPO Console
?
Yes
No
Modify current configurations
to include ClearPath HMP IX
nodes and automation
2200 Node Hardware Verification
1
Figure 1–2. Installation Process Overview
6. Perform a 2200 node system check as follows:
a. Power on the 2200 nodes.
b. Run microdiagnostics.
c. Boot and run SUMMIT.
1–6 Version 009B (Web Only) 7850 5104–009
1
Install and configure SPO server
software (if not preinstalled)
Copy SPO server hosts
file to system consoles
Install and configure SPO
workstation software
If using SPO Console, install
temporary license key and
submit registration form for
permanent key. (Skip if using
SPO Basic Edition.)
Install SPO agents
on Intel nodes
Install and configure
OS2200IOEsoftwareon
2200 node
Run interconnect tests to verify
2200 node to Intel nodes
communications
Use Integration Expert to
customize the configuration