ClearPath IX Systems Installation and Configuration Guide
24.12.2012 • Views
Share Embed Flag

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

SHOW MORE
SHOW LESS
ePAPER READ
DOWNLOAD ePAPER
public.support.unisys.com

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

START NOW

1.2.2. <strong>Installation</strong> Procedure Overview<br />

Introduction <strong>and</strong> <strong>Installation</strong> Overview<br />

This subsection briefly describes the overall <strong>ClearPath</strong> <strong>IX</strong> server installation procedure.<br />

Figure 1–2 illustrates the steps. The procedure identifies sections with detailed<br />

information.<br />

Hardware <strong>and</strong> Plateau Software <strong>Installation</strong><br />

These are the main steps covered in this manual:<br />

1. Install <strong>and</strong> cable all <strong>ClearPath</strong> <strong>IX</strong> server hardware. Refer to the Unisys e-@ction<br />

Enterprise Servers <strong>IX</strong>4800/<strong>IX</strong>5000/<strong>IX</strong>6000 Servers <strong>Installation</strong> <strong>and</strong> Servicing<br />

Reference (7842 5980)for additional information.<br />

2. Configure the monitor concentrator (switch box). Refer to 2.5.1.<br />

3. Switch the monitor concentrator to the SCF master position (2.5.2), power on the SCF<br />

master console, <strong>and</strong> install <strong>and</strong> configure SCF workstation software. For all SCF<br />

software installation steps, use procedures described in the Unisys e-@ction<br />

<strong>ClearPath</strong> Enterprise Servers <strong>IX</strong>4800/<strong>IX</strong>5000/<strong>IX</strong>6000 Series <strong>Systems</strong> Plateau<br />

Customer Reference Manual (7859 5774).<br />

Note: While system console software is loading, you can switch the monitor<br />

concentrator to the Intel node position <strong>and</strong> install Windows NT or UnixWare<br />

IOE software (step 9).<br />

4. Take the following steps to load the SCMS database <strong>and</strong> operations database (ODB)<br />

files:<br />

a. Reboot the 2200 node master console in site data facility (SDF) online mode, <strong>and</strong><br />

load the factory-built customer SCMS database.<br />

b. Reboot the master console in SCF offline mode <strong>and</strong> load the factory-built<br />

customer ODB files.<br />

c. Reboot the master console in SCF online mode.<br />

5. Repeat steps 3 <strong>and</strong> 4 for optional backup master SCF console. Repeat step 4 for<br />

optional slave SCF consoles.<br />

Note: Once the operating system tape has been loaded on the master system<br />

console, you can remove the boot diskette <strong>and</strong> tape <strong>and</strong> start loading the<br />

operating system tape on the next system console.<br />

7850 5104–009 Version 009B (Web Only) 1–5

logo

products

Resources

Company

Terms of service
Privacy policy
Cookie policy
Cookie settings
Imprint
Change language
Made with love in Switzerland
© 2024 Yumpu.com all rights reserved

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!