ClearPath IX Systems Installation and Configuration Guide

Installing OPE and SysAdmin
7. Enter OPE. You are prompted for the product level.
n-INSPKG*Enter product level
n level
8. Enter level (where level is the product level identified on the tape label, such as 4R1A)
and press Enter. You are prompted for the product mode.
n-INSPKG*Enter product mode
n A
9. Type A and press Enter. You are again prompted for the product name.
n-INSPKG*Enter product name, transmit if complete
n
10. Press Enter to indicate that you are done. Both OPE and SysAdmin are loaded from
the tape. You are prompted to verify that you specified the correct reel by messages
such as these:
LOAD OPE T40A12 NORING PP$TAPE - 1 INSPKG
(LOAD OPE )(ANY UNASSIGNED CT0899 )
The following message indicates that the run is finished:
INSPKG FIN
To use the Network File System (NFS) features provided by OPE, the site must update the
/etc/hosts file of OPE as follows:
• The 2200 node host name must match the name displayed by the OPE uname -n
command.
• Entries must be added for any remote systems that will be accessed as NFS clients.
After you update the /etc/hosts file, normal NFS administrative tasks can be performed.
E–2 Version 009B (Web Only) 7850 5104–009