ClearPath IX Systems Installation and Configuration Guide

Appendix E
Installing OPE and SysAdmin
This appendix gives installation instructions for two of the optional IOE products provided
with the ClearPath system, OPE and SysAdmin.
OPE and SysAdmin are part of the standard IOE software package. They are packaged
together on the OPE tape. They are installed on a 2200 node, where OPE provides the
UNIX-compatible environment and basic open services needed by SysAdmin.
Use the INSTALLPKG runstream with an install mode of A to install both products at the
same time, as follows:
1. Enter the following command to start the installation runstream:
ST INSTALLPKG
2. A run (run-id INSPKG) starts and asks the following question:
INSPKG START
n-INSPKG*Install from , DISK, or RSS?
n
3. Press Enter to use the tape default. You are prompted to enter the reel number.
n-INSPKG*Enter reel number
n OPE,TJ,type
4. Because the tape is unlabeled, you can enter any reel number. Also enter the
parameters to indicate that the tape is to be assigned as a temporary unlabeled file
(TJ) and to indicate the type of cartridge device on which the tape is to be mounted
(for example, HICL or HIC51).
You are asked whether you want to install using default modes.
n-INSPKG*Install default modes? /N
n N
5. Press Enter to install using the default modes. A message asks if you want to register
the INSPKG:
n INSPKG* Register package also? Y/
n
6. Enter (transmit) to accept the default. You are prompted for the product name.
n-INSPKG*Enter product name, transmit if complete
n OPE
7850 5104–009 Version 009B (Web Only) E–1