ClearPath IX Systems Installation and Configuration Guide

INVENTORY_INCLUDE: Limited Comprehensive
Generic Inventory Information
Enter info. for PCC-500
at location CAB
Features associated with: PCC-500.PCC0
Select features for the above component.
Configuring the FDDI Interconnect
# Used # Left Feature Name Description
x x xxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
x x xxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
1 7 IOPM-BMC-4.5 Block I/O Module 4.5 or 3.0 m/s
F9=Add feature F10=Subtract feature
3. Configure the HLC-2 to match the hardware configuration as follows:
a. Add an HLC-2 unit to inventory and assign it whatever name is appropriate for the
site.
b. Add the FDDI feature to location 00 (the A position) in the HLC-2. Make sure the
feature component name for the first control unit is FDDIVI. SCMS automatically
names the devices as HLVI01 (address=1 type=output) and HLVI02 (address=2
type=input). Do not change those names.
Add additional control units for additional Intel nodes, as needed, and name them
as follows:
• FDDIVJ (device names HLVJ01 and HLVJ02 are generated by default) for
control unit 2
• FDDIVK (device names HLVK01 and HLVK02 are generated by default) for
control unit 3
• FDDIVL (device names HLVL01 and HLVL02 are generated by default) for
control unit 4
Note: These names are required for later use by automated configuration
tools. Either device name (it does not matter which) can be assigned as
input or output.
c. Exit from the inventory add procedure.
d. Modify inventory to add the Ethernet feature to the HLC-2 in location 01 (the B
position).
e. Exit to the main menu of SCMS.
f. Use System_include to include the HLC-2 in the system configuration.
7850 5104–009 Version 009B (Web Only) D–3
i02
i18