ClearPath IX Systems Installation and Configuration Guide

Section 17
Installing Optional OS 2200 Software
from the Package Tapes
After you have customized the site (Section 16), you can install optional OS 2200 software
from package tapes.
Caution
When reinstalling products, do not attempt to install them in package tape
numerical order. Products must be installed in an order described in the
ClearPath HMP IX and 2200 Systems Software Planning and Migration Overview.
OS 2200 products available on keyed package tapes are listed in ClearPath HMP IX and
2200 Systems Software Planning and Migration Overview. To install a product from a
keyed package tape, you must
1. Register the key tape (labeled KEYTAPE) using the procedure in 17.1.
2. Refer to the documents listed in 17.2 for installation instructions.
17.1. Registering the OS 2200 Product Key Tape
Registering the product key tape is required to install optional products from package tape.
To register the product key tape, take the following steps:
1. Start the runstream for registering the key tape by entering the following command:
ST REGISTERPKG
The following message appears:
n Register package from or DISK?
n
2. Press Enter to select the default location of the key tape. A prompt asks for entry of
the reel number from which the key is to be installed.
n Enter reel number
n CPKEY,TJ,type
7850 5104–009 Version 009B (Web Only) 17–1