ClearPath IX Systems Installation and Configuration Guide

Customizing the Site
5. Select the Hosts File menu bar item, then press Enter.
A list of options appears as follows:
Load
Save
Exit
6. Select Load, then press Enter.
7. Press the up or down arrow keys to get the following drop down list:
DOS-HD
DOS-DD
UNIX
8. Use the arrow keys to select the UNIX option, then press Enter.
9. Tab to the Host Name field, enter the site-defined name of the console you are loading.
The Execute box appears.
10. Again press Enter.
You are prompted to insert the diskette.
11. Insert the diskette with the hosts file on it, then press Enter.
A window appears indicating that the system is working and that you should wait.
When the system completes loading the hosts file, it returns to the Single Point
Interface Utility window.
12. If you do not have a router, skip this step. If you have a router, add router information
as follows:
a. Select the Routers menu bar item.
A list of options appears as follows:
Add Router
Delete Router
Display Routers
b. Select Add Router, then press Enter.
An Add Router window appears.
c. Enter information in that window as follows:
• In the top portion enter the IP address and host name that defines the
destination of messages to be routed through the router. That destination can
be either a network or a host.
• In the bottom portion, enter the IP address and host name of the router.
13. When done, press Enter.
The Single Point Interface Utility window reappears.
16–10 Version 009B (Web Only) 7850 5104–009