ClearPath IX Systems Installation and Configuration Guide

Customizing the Site
lan-address lan-node-name alias1.. ..aliasn # comment
192.168.57.3 newIntelnode1-name Intelnode1-name cp_nt1
192.168.57.4 newIntelnode3-name Intelnode3-name CP_UNIX1
192.168.57.6 fddi22am # reserved for OPE
192.168.57.7 fddi22mr # reserved for MAPPER
192.168.57.23 newIntelnode2-name Intelnode2-name cp_nt2
192.168.57.24 newIntelnode4-name Intelnode4-name CP_UNIX2
192.168.58.15 newsposerver-name sposerver-name SPO_Server
Example 16–4. UnixWare Node Hosts File Format after Editing
16.5.3. Copying the Modified SPO Server Hosts File to the System
Consoles
After being modified, the newly edited SPO server hosts file should be copied to diskette
and then loaded at each of the 2200 system consoles.
Copying the Modified File to Diskette
To copy the modified hosts file from the SPO server to diskette, take the following steps:
1. If not already logged on at the SPO server, log on as superuser (10.15).
2. Place a diskette into the drive unit of the SPO server and enter the following
commands to copy the hosts file to diskette:
cd /etc/inet
tar cvf /dev/rdsk/f03ht ./hosts
Loading the Hosts File to a System Console
To load the new hosts file on each 2200 node system console, take the following steps:
1. On the system console, press F3.
The Utilities Session menu appears (Figure 10–2).
2. Select Optional Features, then press Enter.
A list of utilities appears as follows:
AMS Utility
USP Utility
USP APFG Utility
SP Interface Utility
3. Select SP Interface Utility, then press Enter.
An execute box appears.
4. Press Enter.
The Single Point Interface Utility window appears.
7850 5104–009 Version 009B (Web Only) 16–9