ClearPath IX Systems Installation and Configuration Guide

APP 3 ROLLBACK INITIALIZATION STARTED
APP 3 ROLLBACK INITIALIZATION COMPLETE
SETUP3**WARNING* 5807 App 3 UDS is not configured
Installing the Remaining IOE Software
SETUP3*App 3 AOR phase not required
0-EXEC 8 REQUIRES AUDIT TRAIL: 3 ANS. OP, E, OR DN
3. Open an audit trail by making the following entry:
0 OP
More messages appear. The SETUP3 FIN message indicates that the runstream has
finished.
AT 3 ACI$03(1) *FILE ASSIGNED* 1103:18
AT 3 L1 FIX(1,1) *OPEN* 1103:19
AT 3 L1 BLK 1 TBSN 0 1103:19
AT 3 OP
APP 3 RESTARTED
SETUP3*App 3 short recovery complete
AT 3 S1 FIX(2,2) *SPARE* 1103:19
SETUP3 FIN
After the SETUP3 FIN message appears, proceed with installing UDS application group 3
as described in the next subsection.
15.2.4. Installing UDS Application Group 3 from Fast-Load Tape
HMP-UDS3
After application 3 has been set up, you can take the following steps to install the default
UDS application group 3 from fast-load tape HMP-UDS3:
1. Enter the following command to start MCB:
ST MCB3
MCB initialization messages appear as follows:
MCB3 START
MCB3 *MCB 8R1A 8R1A (A3)
MCB3 *(940914 1058:42) 1996 May 30 Thu 1103:37
MCB3 *MCB INITIALIZATION COMPLETE 96/05/30 1103:40
2. Enter the following command to start the runstream that installs UDS application
group 3:
ST INSTALLAPP3
That runstream installs and registers the following products from the HMP-UDS3 tape.
• Data Management System (DMS 2200)
• Relational Data Management System (RDMS 2200)
• Shared File System (SFS 2200)
• Universal Data System Control (UDSC)
7850 5104–009 Version 009B (Web Only) 15–5