24.12.2012 Views

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Installing the Remaining IOE Software<br />

15.2.3. Setting Up Application Group 3<br />

To set up application group 3 so that the UDS tape can be installed, take the following<br />

steps:<br />

1. Application group 3 must be up to start this procedure. Take these steps to check its<br />

state:<br />

a. Check the facility status of the application by entering this comm<strong>and</strong>:<br />

AP 3 FS<br />

The following message should be returned to indicate that IRU short recovery is<br />

pending (“PND”) <strong>and</strong> is in the “INIT” recovery state:<br />

APP 3 RCV 0% IRU:PND REC: INIT<br />

b. If a message indicates that application group 3 is not in the correct recovery state,<br />

enter the following comm<strong>and</strong>s:<br />

AP 3 DN<br />

AP 3 UP INIT<br />

2. Enter the following comm<strong>and</strong> to start the runstream to set up application group 3:<br />

ST AP3SETUP<br />

This runstream does the following to perform an IRU short recovery of application<br />

group 3 (required to set up the application group):<br />

• Creates rollback page file to TIP file 301<br />

• Adds the MCBSETUP3 runstream<br />

• Sets up the IRU history file for application group 3<br />

• Adds the IRU3 runstream to short recover application group 3<br />

Messages appear <strong>and</strong> you are prompted to open an audit trail.<br />

Note: The common bank error messages appear as a result of UDS products not<br />

yet being installed when IRU short recovers application group 3 during the<br />

initial set up. Application group 3 must be up <strong>and</strong> short-recovered when<br />

UDS is initially installed (15.2.4).<br />

SETUP3 START<br />

SETUP3*MSG: CREATE ROLLBACK PAGE FILE FOR APP3<br />

SETUP3*MCB File Setup 8R1A 8R1A (A3)<br />

SETUP3*(940914 1100:56) 1996 May 30 Thu 1103:14<br />

SETUP3*MCB IRU Setup 8R1A 8R1A (A3)<br />

SETUP3*(940914 1101:16) 1996 May 30 Thu 1103:15<br />

SETUP3*MSG: CREATE IRU HISTORY FOR APP 3<br />

SETUP3*MSG: PERFORMING A SHORT RECOVERY OF UDSSRC<br />

Common bank error 9 . -0-><br />

-0-> common bank " UNDETERMINED " with bdi 400665 -0-><br />

-0-> referenced by run-id " SETUP3 " is not installed.<br />

Common bank error 9. bdi 400665 not found -0-><br />

-0-> in omnibus element BANK-BDI$<br />

-0-> in file SYS$*LIB$(1) .<br />

SETUP3*App 3 Init of MCB complete<br />

15–4 Version 009B (Web Only) 7850 5104–009

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!