ClearPath IX Systems Installation and Configuration Guide

Installing the Remaining IOE Software
15.2.1. Installing TIPUTIL, MCB, and DPS from Fast-Load Tape
HMP-OE2
Note: The runstream used to install TIPUTIL, MCB, and DPS (INSTALLPKG) is a
generic runstream used to install products from tape. This same runstream
can be used to install optional products from package tapes.
The tape HMP-OE2 contains products (TIPUTIL, MCB, and DPS) that may or may not need
to be configured to your particular needs. Use the INSTALLPKG runstream to install those
products in default mode as follows:
1. Enter the following command to start the installation runstream:
ST INSTALLPKG
You are prompted to select the installation source.
INSPKG START
n-INSPKG*Install from , DISK, or RSS?
n
2. Enter the default to select TAPE as the source. You are prompted to enter the reel
number.
n-INSPKG*Enter reel number
n
3. Because the tape is unlabeled, you can enter any reel number. Also enter the
parameters to indicate that the tape is to be assigned as a temporary unlabeled file
(TJ) and to indicate the type of the cartridge device on which the tape is to be
mounted:
n HMPOE2,TJ,type
where type is, for instance, HICL or HIC51.
In response, you are asked whether the installation is in default mode.
n-INSPKG*Install default modes? /N
n
4. Press Enter to install using the default modes. A message asks if you want to register
the INSPKG:
n INSPKG* Register package also? Y/
n
6. Enter (transmit) to accept the default. You are prompted to verify that the unlabeled
tape you mounted is the correct reel.
LOAD HMPOE2 T40A12 NORING PP$TAPE - 1 INSPKG
(LOAD HMPOE2 )(ANY UNASSIGNED CT0899 )
INSPKG FIN
The INSPKG FIN message indicates that the runstream has finished. Proceed with setting
up the TIP environment as described in the next subsection.
15–2 Version 009B (Web Only) 7850 5104–009