24.12.2012 Views

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

ClearPath IX Systems Installation and Configuration Guide

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Verifying the Interconnects <strong>and</strong> Achieving Hardware RFU<br />

Continue with either 14.5.1 or 14.5.2, as determined above.<br />

14.5.1. Starting the PING Run<br />

This subsection describes the quickest way to prepare for hardware verification: the PING<br />

run (PING-RUN). PING-RUN brings up a minimal version of CMS 1100 that supports only<br />

the interconnect communications test (PING test). When the test is complete, the CMS<br />

1100 run started by PING-RUN must be terminated <strong>and</strong> a new CMS 1100 configured <strong>and</strong><br />

started by the site.<br />

Note: The CMS 1100 run started by PING-RUN cannot be used to verify public or SPO<br />

network connections. To create a CMS 1100 that can be left on the system <strong>and</strong><br />

enhanced after hardware verification, follow the procedures in 14.5.2 instead.<br />

To use PING-RUN, take the following steps:<br />

1. Access an OS 2200 console session at either the SPO workstation or at the monitor<br />

concentrator.<br />

2. Enter one of the following console key-ins to start the setup run:<br />

• If this is the only 2200 node, or the first 2200 node in a resilient partition, enter the<br />

following keyin:<br />

ST PING-RUN<br />

A run called CMS starts.<br />

• If this is the second 2200 node in a resilient partition, enter the following keyin:<br />

ST PING-RUN2<br />

A run called CMS2 starts.<br />

Messages similar to the following indicate that CMS 1100 has access to the LAN:<br />

CONFIGURATION ERRORS(0) WARNINGS(0)<br />

LAN FDDIVI FDDI HLC IS USING MICROCODE LEVEL 006.52<br />

LAN FDDIVI MAC ADDRESS = 02E6D3070058<br />

Continue by executing the PING test as described in 14.6.<br />

14.5.2. Bringing Up CMS 1100<br />

This subsection describes basic CMS 1100 configuration considerations <strong>and</strong> considerations<br />

for implementing the <strong>IX</strong> Network Identity Repository (16.2).<br />

To complete the load process <strong>and</strong> verify the system, the site must use CMS 1100. This<br />

subsection gives the procedures for creating a minimum CMS 1100 configuration that is<br />

tailored to the installed external Ethernet LAN. Once the steps in this section are<br />

completed, CMS 1100 is ready to use.<br />

7850 5104–009 Version 009B (Web Only) 14–9

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!