ClearPath IX Systems Installation and Configuration Guide

Verifying the Interconnects and Achieving Hardware RFU
10. Enter ETHER as the product mode and press Enter. You are again prompted for the
product name.
n Enter product name, transmit if complete
11. Press Enter to indicate that you are done. Loading begins, and you are prompted to
verify that the unlabeled tape you mounted is the correct reel.
LOAD HLC2M T40Z0 NORING PP$TAPE - 1 INSPKK
(LOAD HLC2M )(ANY UNASSIGNED CT0899 )
n ANSWER WITH REEL NO ON T40Z0 E,REEL
n HLC2M
The following message indicates when the run is finished:
INSPKG FIN
When CMS 1100 is started, it detects the new microcode level and automatically loads the
microcode into the HLC-2.
14.2.2. Installing Channel Adapter Microcode (CSIOP)
To enable CSIOP communications, you must install Ethernet and FDDI channel adapter
(CA) production mode microcode into the CAs.
To install the microcode from the FDDI/Ethernet CA-MCODE tape, take the following
steps:
1. Enter the following command at the 2200 node system console:
ST INSTALLPKG
A run (run-id INSPKG) starts and asks the following question:
n Install from , DISK, or RSS?
n
2. Press Enter to use the tape default. You are prompted to enter the reel number.
n INSPKG*Enter reel number
n CACODE,TJ,type
3. Because the tape is unlabeled, you can enter any reel number. Also enter the
parameters to indicate that the tape is to be assigned as a temporary unlabeled file
(TJ) and to indicate the type of the cartridge device on which the tape is to be
mounted (for example, HICL or HIC51).
You are asked whether you want to install using default modes.
n Install default modes? /N
n N
4. Enter no (N) and press Enter. You are prompted to enter the product name.
n Enter product name, transmit if complete
n CA-MCODE
14–4 Version 009B (Web Only) 7850 5104–009