ClearPath IX Systems Installation and Configuration Guide

Installing the Basic OS 2200 IOE
You only need to register the Exec key tape or file once because the data is stored in the
SOLAR SYS$*DATA$ file for recovery boots and a backup copy is written by the Exec to
the disk-resident system (DRS) device. The SCP data recovery first tries the SYS$*DATA$
file and alternately the DRS device. The DRS device SCP data is used if a SYS$*DATA$ file
does not exist or an Exec key tape was never registered.
Continue product installation with the procedure in 13.5.
13.5. Installing Products from Tape HMP-OE1
Notes:
• Although Interactive Processing Facility (IPF 1100) is installed from fast-load tape
HMP-OE1, it cannot be used in full-screen mode until Display Processing System
(DPS 2200) is installed. If the site needs to use IPF 1100 in full-screen mode, DPS
2200 should be installed from either fast-load tape HMP-OE2 or package tape
HMP12 (see Section 15) after hardware RFU.
• During installation of products from HMP-OE1, you can ignore warning messages
relating to installation of an IPF component at this time. The Interactive
Processing Facility (IPF 1100) can be configured after installation. Configuration
instructions are in the IPF 1100 Administration Guide.
• The IOE products on tape HMP-OE1 are installed in default mode.
Follow these steps to install the IOE products on tape HMP-OE1:
1. Enter the following command to start the installation runstream:
ST INSTALLIOE
2. You are prompted to enter the reel number for the reel or reels you are loading:
INSIOE START
n INSTALLIOE: Enter reel number
3. Because the tape or tapes are unlabeled, you can enter any reel number. For example,
for the HMP-OE1 fast-load tape enter the following to assign the tape as a temporary
file, indicate that it is unlabeled (TJ), and indicate a cartridge tape device:
n HMPOE1,TJ,type
where type is, for example, HICL or HIC51.
Note: If tape HMP-OE1 is a two-tape set, you must enter two reel numbers
separated by a slash (for example, CPOE1A/CPOE1B,TJ,HICL).
The following messages appear:
LOAD HMPOE1 T40A12 TAPE$ - 1 INSIOE
(LOAD HMPOE1 )(ANY UNASSIGNED CT0899 )
n ANSWER WITH REEL NUMBER ON T40A12 E,REEL
7850 5104–009 Version 009B (Web Only) 13–9